Caution:
Do not install retractor to the buckle half of the belt.
Step
1:
Wind
retractor clockwise 7-8 full turns. Be careful while winding,
hold retractor firmly in hand.
Step
2:
Turn
belt over with opposite hand. Push belt under tabs. Position retractor
in the middle of the outboard belt webbing (Figures 1 and 2).
Step
3:
Position
retractor squarely with belt and crimp tabs securely against belt
webbing (Figure 3).
Step
4:
Check
for proper operation of retractor and make any adjustments required.
Note:
If it is necessary to rewind retractor, do not exceed 9 full turns.
Seat
belt must be fully extended when in use. Pull belt so it is fully
unwound from the retractor, then connect the belt and make adjustments
at the buckle for proper fit.
* Please be advised that this information is for suggestion only and is based on prior experience. We at CJ Pony Parts can not be held responsible or liable for any mistakes or injuries connected with the topics covered.
Ford, Mustang, Bullitt, Mach 1, Cobra, Shelby and SVT are registered trademarks of Ford Motor Company. CJ Pony Parts, Inc has no affiliation with Ford Motor Company. Throughout this website and catalog these terms are used for identification purposes only. Mustang parts for early model and late model Ford Mustangs. We carry everything you need to restore your classic mustang or enhance any Mustangsperformance. Mustang Parts. mustang parts. 64-73,64-66,67-68,69-70,71-73,79-93,87-93,94-98,94-04,99-04,05-07