1" Carburetor To Intake Manifold Spacer for 1965-1969 Mustangs with a 4 Barrel Carburetor on a 289, 302 or 351W Engine.This spacer mounts between the carburetor and the intake manifold. It raises the carburetor and increases the intake manifold runner length. Measures 1" thick with a 1-9/16" bore size on the holes.
Includes a rubber vacuum port plug and spring clamp."
Product ReviewsWrite a review
Carburetor To Intake Manifold Spacer 1" 289/302/351W 4V 1965-1969 is rated out of 5 by 2.
Rated 2 out of 5 by jccool156 from Good looking Product BUT.... This spacer will probably work well on the OEM Intake 4V manifold by ford, but to answer the question below on will it work on other intakes, the answer is no unless they have wide sides for the base plate receiving area. I installed it on a 289 performer intake from Edelbrock, the gasket and spacer hang over the edge on the sides of the base plate(where on the spacer the vacuum channel is located NOT SHOWN ON ANY OF THE IMAGES!!!!! the under side is all open) and when the engine is started up it causes a major vacuum leak.
Date published: 2015-05-13
Rated 5 out of 5 by ac17 from great item and price! fits and looks great on my 1968 302 build. i like that it is a natural finish - my build has no polish or chrome, so it's perfect!
Date published: 2015-05-15
Will this spacer work on a 302 edelbrock 4v aluminum intake, with an autolite 4100 carburator on a 1972 F100. Do I need two gaskets, one one between the intake and spacer, one between the spacer and Carburator. Need to know b4 I purchase.
Unsure. We can only speak to the fitments listed. It may work, but then again it may not. We just haven't tested it.
Date published: 2015-03-31