Console Restoration Kit for all 1987, 1988, 1989, 1990, 1991, 1992 and 1993 Mustangs.Over the years your original console arm rest pad has probably taken a beating from constant use and those harsh UV rays from the sun. This Console Restoration Kit for all 1987-1993 Mustangs comes with everything you need to replace your original console arm rest pad, lower trim panel and hardware.
- Console Arm Rest Pad (1)
- Ford Tooling Console Lid Lower Trim Panel (1)
- Console Lid Lower Trim Panel Screws (4)
Let's face it. The console arm rest pad in your 1987-1993 Mustang has probably seen better days. If it's looking deformed or has developed a few cracks from constant use, now is the time to replace it and get your interior looking fresh. These direct replacement console pads are exact reproductions of the originals. Each pad is constructed from color matched material, not painted like some other aftermarket console pads, for a long lasting finish.
The Ford Tooling console lid lower trim panel mounts underneath the center console arm rest pad. This is the part that takes the most abuse each and every time you open and close the console lid. The trim panel comes with a reinforced catch to help eliminate the chances of breaking along with attached rubber bumpers.
No need to reuse your original hardware, CJ Pony Parts has you covered with the four screws that attach the lower trim panel to the underside of the console pad .
These kits are available in 1987-1993 factory correct colors including, Black, Red, Titanium, and Smoke Gray, but can be painted to match other interior colors.
Product ReviewsWrite a review
You Might Also Like
Regular Price: $94.99
Special Price: $80.74
/** Note: This is used for related configurable parts to properly display price w/o regular price */?>Special Price:$20.36
We're going to start by removing the old piece by pulling out these four Phillips Head screws. You want to make sure that the vinyl for the pad covers this plastic as much as possible. In our case, it's around the edge here a little bit, but just pick it up and pull it back over. The interior can be a little tight, but overall it's not too bad. If your pads in bad shape, we do offer replacements, as well.
Here's the new base for our lid with the proper latch still on it. Pull the vinyl plate against the lid just over the top two screws. Our installation is done. You can see now it works exactly like it's supposed to. A replacement console lid is an easy to install option for a very common problem. The only tool going to be required is going to be a Phillips Head screw driver. Installation should take you no more than about five minutes, so you'll be back on the road in no time.