Covercraft Car Cover Deluxe 380 1965-1968

CJ's Part Number: COVER38065-V
CJ's Low Price:
$204.99
1404950400
Earn 204 RPM Points What's this?
COVER38065-V
COVER38065-V Play Covercraft Car Cover Deluxe 380 1965-1968 Video 1

Product Description

Covercraft Deluxe 380 Running Pony Car Cover for 1965-1968 Mustangs.

380 Series fabric offers great performance at a competitive price. The three-layer construction uses inner and outer layers of spun-bond, sandwiching a middle layer protective film barrier. The film barrier has microscopic holes, smaller than droplets of water (and most dust particles) to stop moisture, but still allow any moisture vapor or heat to easily escape from under the cover. Taupe colored fabric. Available with driver side or driver & passenger side mirror pockets for added protection.

Features:
-Naturally moisture resistant
-Breathable fabric
-Dust/pollution barrier
-Tri-bar logo

*This cover is recommended for outdoor use but can also be an indoor cover.

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review

Product Video

By Bill Tumas: One of the best ways of protecting the investment you made in your Mustang was a good quality car cover. I'm not talking about those cheap one size fits all covers. I'm talking about a custom car cover specifically designed to fit your Mustang. We're going take a closer look at custom car covers from CoverCraft.

CoverCraft offers their Mustang car covers in two different materials. Shown here in gray, on the left, is their Block-It 200 Series. The Block-It 200 is a high potent non-woven fabric that is USA made and designed primarily for indoor use. It is a three-layer polypropylene material for moisture resistance and can be used for limited outdoor, but again, it's designed primarily for indoor use only.

On the right, the tan cover is their Block-It 380 Series. The Block-It 380 is a high performance Kimberly-Clark material that uses two layers with a film in-between. The film is designed to keep out moisture while allowing moisture and heat to escape from underneath the cover.

These covers are designed for both indoor and outdoor use and are UV protected as well. Both the Block-It 200 Series and the Block-It 380 Series have a soft woven liner to protect your paint when installing the cover.

Shown here is a Block-It 380 Series cover on a 1968 Mustang Coupe. This cover will fit all '64 through '68 coupes and convertibles. The fitment is so specific it actually has different models available for both single and dual rearview mirrors.

All CoverCraft covers are going to have the running horse logo on the front, elastic bands for a tighter fit in the front and the rear, a grommet is included for your antenna cutout and two grommets are pre- installed for locking your cover to your vehicle. Your paint job is one of the most expensive parts of your Mustang. Make sure you protect it with a high quality cover from CoverCraft.