Dynacorn Body Bracket Kit Fastback 1967-1968

Dynacorn: 67FBBRKT
CJ's Low Price:
1490572800 44192
Earn 236 RPM Points What's this?
Dynacorn Body Bracket Kit Fastback 1967-1968

Product Description

Dynacorn Body Bracket Kit for all 1967-1968 Fastback Mustangs.

When starting a full restoration on your 1967 or 1968 fastback Mustang, and discover rust on the inside structure of the body, this all new, 37 piece Dynacorn Body Bracket Kit contains all the correct body brackets and bracing your 1967-1968 fastback Mustang needs for a rust free, strong structured body. These are the brackets that are behind the body sheet metal and act as bracing for the inner structure.

This Dynacorn Body Bracket Kit is a great way to insure that your 1967-1968 fastback Mustang won't rust out after the restoration period. These brackets are made of high quality stamped metal. Dynacorn only uses the most up to date tooling in order to get the best and most accurate fit so you know these new brackets will fit just like the original inner bracing.

Restoring your 1967-1968 fastback Mustang can be a massive project. There are wide selections of parts that you may need to replace, and finding quality replacements can be a battle. While there are lots of choices out there, Dynacorn offers the widest selection in parts and some of the highest quality found anywhere. CJ Pony Parts offers a large selection of Dynacorn parts, allowing you to find practically anything you need while restoring your classic Mustang.

Similar Mustang Parts

similar Mustang parts More Body Shells & Frame Assemblies  

Installation Instructions

Mustang Installation

Mustang Applications

This product will fit the following Mustang years:

Product Reviews

Write a review
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 141.14ms
  • bvseo-msg: HTTP status code of 404 was returned;

Product Questions

Hello, Can these parts be bought separately?

Asked by: fritz555
No they cannot.
Answered by: rk cjpp
Date published: 2016-12-29

Does anyone have a drawing that would show the correct location for all these brackets? Specifically the ones for the hold down seat, and lower rear panels. I bought this kit but have replaced my wheel tubs and floors and the original brackets were gone

Asked by: JimmyJ
I found there is a good diagram in the Jim Osborne body assembly manual for the 66 mustang, the bracket locations are very similar if not identical, for some reason this diagram is not in the 67 manual.
Answered by: rk cjpp
Date published: 2016-04-20
  • y_2017, m_3, d_26, h_23CST
  • bvseo_bulk, prod_bvqa, vn_bulk_1.0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_2
  • loc_en_US, sid_67FBBRKT, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 241.41ms

You Might Also Like