Dynacorn Driver Side Seat Platform In Weld-Thru Primer for 1969-1970 Mustang Coupes and Fastbacks.When you are replacing your floor pans, new seat platforms are a recommended upgrade. It would be difficult to drive your Mustang without a properly mounted seat. Dynacorn's high-quality, low profile seat platform mounts to the top of the floor pan where the front seat bolts directly to it. Features a reinforcement brace on the underside of the seat platform, just like the original, and a weld-thru primer finish.
Advantages of Weld-Thru Primer:
- Reduces prep time when welding new parts to new parts that are both covered in the weld thru primer
- Reduced spatter
- Lower distortion of the panels
- Superior conductive properties that help minimize high heat zone problems
- Eliminates corrosion that would form between overlapped panels or multi-layered spot welds
- Helps when welding a new panel to old metal
- Lower resistance at the weld surface allows better penetration into the denser, new steel that helps forgive an old alloy's problems with porosity and impurities
- Helps prevent resin build up between welds that can trap moisture in the old porous steel that leads to failure at the weld borders
*The raised seat platform must be welded to the floor pan for a correct installation!
|Fits 1969-1970 Mercury Cougar Coupes|
Product ReviewsWrite a review
Dynacorn Seat Platform In Weld-Thru Primer Driver Side Coupe/Fastback 1969-1970 is rated out of 5 by 1.
Rated 5 out of 5 by Superricochet from very good spare parts I bought this a days ago and am so happy, cj pony parts is a very serious product highly recommend them
Date published: 2016-04-02
is this Made in America
I think Dynacorn makes many of their products overseas, though I can't say for certain about this one.
Date published: 2015-03-30
You Might Also Like
CJ's Low Price:$81.99
CJ's Low Price:$188.99