Eastwood 10-Piece Bearing and Seal Driver Set.Eastwood's Bearing and Seal Driver Set is a must for anyone installing bearings and seals in wheel hubs, engines and suspension components. The set includes nine drivers and one driver handle to help you easily replace bearings without damaging the bearing or housing. Included collars fit most wheel bearing sizes and they're organized so you can easily locate the driver needed.
When installing bearings or seals, you must be sure to install the bearing/seal straight, fully seat the bearing/seal and not damage the bearing/seal during installation. A bearing and seal driver kit is meant to aid you in the installation and help you get the job done on your first try. The driver set is made from aluminum so it will not gall the parts you install.
- 1.555" (39.5mm)
- 1.752" (44.5 mm)
- 1.969" (50 mm)
- 2.323" (59 mm)
- 2.480" (63 mm)
- 2.559" (65 mm)
- 2.835" (72 mm)
- 2.992" (76 mm)
- 3.189" (81mm)
- Drive Handle
- Storage Case
Don't go looking for that block of wood anymore. This bearing and seal driver set from Eastwood makes installing bearings and seals an easy task. Drive a bearing home without any nicks or install a seal straight the first time around. Collars have various diameters and they are cut at angles to fit just about any size in between.
Similar Mustang PartsMore Tools & Supplies
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
Would this kit work on mitsubishi evolution front and rear wheel bearing
Can I use this to remove a civic 2007 front bearing? It is a press in bearing
Will this item (Eastwood: 14533) work on a 2005 Ford Escape XL. I need to use it on front and back wheel bearings?
Is it ezy to use with no problems
when is this product going to be available.
Any idea as when this may be available???
What is the lead time on this product? Eastwood: 14533
dose it work with a slide hammer
You Might Also Like