Eastwood 3 Piece External Coil Spring Compressor.For safe installation and removal of coil springs, use Eastwood's External Coil Spring Compressor. The external coil spring compressor works where an internal-type compressor won't.
Includes three 5/8" diameter shafts, three safety hooks and instructions. Unlike conventional internal compressors, the three shafts fit on the outside of the spring, so you can remove and install springs on virtually any vehicle. The three safety hooks accommodate coils up to 3/4" diameter and are designed only to retain the tool on the spring and not secure the actual "finger".
Made in the USA!
*Not for use on MacPherson struts.
Similar Mustang PartsMore Mustang Springs
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
Eastwood Coil Spring Compressor 3 Piece External is rated out of 5 by 2.
Rated 5 out of 5 by Roofgunner from These are good! They state that this is and external compressor but what makes it good is that it can be used internally. I did all the springs on my 65 Cutlass/442 with this tool.( I had an internal compressor but on the Cutlass springs the arms will not grip the coils. ) I put two of the compressors inside the spring on one side and in the correct position which put a slight bend in the spring which is necessary for installation and with two of them it made it safe in case on failed. Once the spring is in place I raised lower control arm a little and removed both compressors through the bottom hole in the arm in pieces. Very easy and safe.
Date published: 2015-01-13
Rated 5 out of 5 by Stlcard12 from Worked like a charm! I used this tool to help with the installation of front shock absorbers. Couldn't have done it with out the tool. The tool itself is very robust and safe, so I had no worries about breakage and little concern of getting hurt when using it.
Date published: 2015-04-01
How long are the rods?
You Might Also Like
CJ's Low Price:$33.99