Eastwood Dual Voltage HotCoat Powder Coating Gun.Stop spray painting your Mustang parts. Use this Dual Voltage HotCoat Powder Coating Gun from Eastwood and get professional powder coating results in your own garage!
With Eastwood's Dual Voltage HotCoat Powder Coating Gun, you can powder coat small parts and hard-to-reach corners using the low 15,000 volt setting, or switch to the high 25,000 volt setting for heavier coverage over larger areas with increased powder adhesion and minimal overspray.
Powder coating is far superior to any other finish available. It's more resistant to chipping, scratches, fading and wear than other finish. The color options are virtually unlimited, with high and low gloss, metallic, and clear finishes available. With the UV resistant qualities of many of the powders, colors stay bright and vibrant longer. Texture selections range from smooth surfaces to a wrinkled or matte finish, plus rough textures designed for hiding surface imperfections.
One 8 ounce bottle of powder covers the same area as 2-3 cans of spray paint. Clean-up is easy, since you can just simply sweep-up the oversprayed powder.
Powder Coating Benefits:
- Extremely Durable Finish
- Coat and Cure in Under 1 Hour
- Easy to Apply
- Quick Color Changes
- Contains No Environmentally Harmful Solvents
Dual Voltage HotCoat Powder Coating Gun Features:
- Versatile with 2 Settings
- Low 15,000 Volt Setting
- High 25,000 Volt Setting
- Increased Powder Adhesion
- Minimal Overspray
- Dual Voltage HotCoat Powder Coating Gun
- Dual Voltage Power Supply
- Activation Switch
- Ground Clamp with Cable
- 1/4" NPT Air Fitting
- Empty 8 Ounce Bottle
*Dual Voltage HotCoat Powder Coating System requires a 5-10 psi compressed air source and a dedicated electric oven (or toaster oven) set at 400F for 20 minutes.
Tech Tip: Fill the bottle no more than 1/4 to 1/3 full and wave the nozzle in a circular motion about 4-6" from the surface to keep the powder flowing efficiently and coat evenly. Use 8 psi for best results.
Please Note: Use a disposable dust mask when handling or applying powder coating. The powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep-up immediately after use, do not vacuum the powder from the floor. Cure the powder coated part in a well-ventilated area. The urethane powder coating Eastwood sells produces a very small amount of Isocyanates when the powder flows out of the gun. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh cartridges when curing or inspecting flow-out progress.
Similar Mustang PartsMore Mustang Paints & Dyes
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
You Might Also Like
CJ's Low Price:$209.99