AMK Products Master Engine Fastener Kit for 1968-1969 Mustangs with a 390 GT Engine.This Master Engine Fastener Kit from AMK Products includes 138 total pieces of factory correct, OE style fasteners that are required to properly reassemble the engine components which attach to the long-block on your 1968-1969 Mustang's 390 GT engine. This kit is specifically assembled for 1968-1969 Mustangs equipped with a 390 GT engine.
AMK Products' Master Engine Fastener Kit includes individually packaged sets of hardware for various applications on your 1968-1969 Mustang's 390 GT engine. Each package is thoroughly labeled so you know exactly where it goes on your FE big block engine. The individual sets of hardware also include the total number of pieces that are required for the specific application. Most of the included fasteners are either meticulous reproductions of the originals or new old stock!
Master Engine Fastener Kit Includes:
- Air Cleaner: Stamped Wing Nut (1)
- Air Cleaner Heat Shroud: Nut/Conical Spring Washer Assembly (2)
- Carburetor: Studs, 7/16" Nuts (8)
- Crank Pulley: Hex Place Bolts (3)
- Crankshaft Damper: Hex Bolt, Flat Washer (2)
- Distributor: Hex Screw/Split Washer Assembly (1)
- Distributor Points and Condenser Single: Slot Pan Head Machine Screws (3)
- Distributor Vacuum Unit: Slot Pan Head Screws (2)
- Engine Block Drain Plugs: External Hex Pipe Plugs (2)
- Engine Fan to Clutch: Hex Screw/Split Washer Assembly (4)
- Engine Fan Clutch to Water Pump: 7/16" Hex Screw/Split Washer Assembly, "SEMS" (4)
- Exhaust Manifolds: Special Ramp-Lok Bolts, 2 with Studs (32)
- Fuel Pump: Hex Screw/Split Washer Assembly (2)
- Ignition Coil Strap and Bracket: Hex Screw/Split Washer Assembly, Hex Washer Head Screw, Hex Nut (3)
- Intake Manifold: Hex Place Bolts, Spacers (12)
- Oil Filter Adapter: Hex Screw/Split Washer Assembly (4)
- Oil Pan: Special Hex Screw/Split Washer Assembly (20)
- PCV Hoses: Wire Clamps (4)
- Starter: Hex Screw/Split Washer Assembly (3)
- Timing Cover: Hex Washer Head Screws, Hex Bolt, Hex Machine Screws (10)
- Valve Covers: Special Hex Screw/Split Washer Assembly (10)
- Water Neck: Hex Screw/Split Washer Assembly (2)
- Water Pump: Hex Screw/Split Washer Assembly, Hex Bolt at Lower Right Side (4)
Buying individual sets of engine hardware for your 1968-1969 Mustang's 390 GT engine can be expensive and time consuming if you're not sure which hardware you need. This Master Engine Fastener Kit makes it easy by including authentic style hardware that specifically fits your 1968-1969 Mustang equipped with a 390 GT engine. With a Master Engine Fastener Kit from AMK Products, you will not only save time and money, but you will have the confidence knowing your 1968-1969 Mustang's 390 GT engine is going to be reassembled with the finest factory correct hardware on the market!
AMK Products produces the most factory correct hardware for your classic Mustang. No matter what kind of Mustang you're building, there's no company better for nuts and bolts than AMK Products!