Passenger Side Long Front Floor Pan for 1965-1970 Mustangs.This heavy gauged stamped steel floor pan starts behind the seat platform and extends forward to the floor to firewall extension. Measures 38-3/4" x 24".
Note: This floor pan has the outside lip bent down which is proper for a convertible. Coupes and fastbacks were bent up. You can either bend it up or remove it and seam weld the pan to the rocker.
Product ReviewsWrite a review
Floor Pan Long Front Passenger Side 1965-1970 is rated out of 5 by 3.
Rated 4 out of 5 by Wayne M from My experience with this panel I purchased this about 6 weeks ago and am just getting around to doing the install. After cutting out the poor repair don’t years ago and doing a fit of the new panel I noticed that the toe area in the car had reinforcing ribs that the new panel did not have. The old repair had removed more of the old floor that the new panel would cover so I have to scab in a small piece to cover about 2" to cover that area. The rear of the new panel does not extend past the seat platform so I have had to add a piece there also to make up for the rusted area under the platform flange. If the new panel had the same ribs in the toe area as the car and were about 2" longer in the front and 1" longer in the rear it would be a super panel in stead of a so-so panel. My installation may have been a bit unusual but there are others with the same issues. I would still recommend this panel.
Date published: 2015-11-18
Rated 5 out of 5 by Woodstock Bernie 1 from perfect for what I needed it for this fit good and was easy to patch in so no one can tell the floor was repaired.
Date published: 2015-11-10
Rated 2 out of 5 by ethansen from Better than welding in a street sign. The panel lip is bent the wrong way. OK for patches.
Date published: 2015-12-11
You Might Also Like