Ford Racing Control Pack for use with the 2011, 2012, 2013 and 2014 4V 5.0L Coyote Crate Engine.
Take the complexity and mystery out of wiring a 2011-2014 5.0L 4V Coyote engine! This control pack from Ford Racing is designed to run the 2011-2014 5.0L 4V crate engine. The unique control pack harness replaces the stock body harness and is designed to work on any vehicle other than a 2011-2014 Mustang. This control pack will work on either an automatic or manual transmission. If your transmission is an automatic it must not have a PCM to control the transmission.
-PCM with Ford Racing Calibration
-Electronic Throttle Control Accelerator Pedal
-OBD-II Diagnostic Port to Assist in Vehicle Calibration Upload and Problem Diagnosis
-Unique Downsized Power Distribution Module
-MAF Sensor with Bolts
*PCM with Ford Racing calibration requires return type fuel system, will not work with return less fuel system.
*Installation of this PCM in a 2011-2014 Mustang GT will result in a no-start condition.
This control pack has everything needed to run the 2011-2014 Coyote engine. The accelerator pedal is electric eliminating the throttle cable, preventing it from getting damaged under the engine bay. This wiring harness also includes an OBD-II port allowing you to diagnose the problems that might occur when finished with your project.
If you're looking for parts for your 1965-2014 Mustang, you should start by looking at the more than 750 Mustang parts that CJ Pony Parts offers from Ford Racing. By buying your Ford Racing parts from CJ Pony Parts, you know you're getting your Mustang parts from a reliable, reputable dealer, since CJ Pony Parts is a Top 10 Ford Racing Dealer and has been for the last 10 years.
Purchase a new Ford Racing Control Pack for use with the 2011, 2012, 2013 and 2014 4V 5.0L Coyote Crate Engine from CJ Pony Parts today!
Similar Mustang PartsMore Computers & Programmers
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
It this Control Pack works with a Coyote Engine 5.0 LT 2014 with a 6R80 Automatic Transmission? The ECU of this pack works with it?
To replace 65 mustang engine with a coyote crate and control pack, what other parts are needed?
Is there a similar kit for a 4.6l 3v engine??
so if I need an oem harness to make this work were would I get an oem harness
so i still need the oem engine harness???
the video says the control pack come with almost everything needed to install the coyote engine into what ever. MY COYOTE ENGINE HAS NO HARNESS ATTACHED TO IT. DOES THIS COME WITH EVERYTHING I NEED TO PLUG INTO ALL THE ENGINE SENSORS AND EVERYTHING.
You Might Also Like
CJ's Low Price:$455.00
CJ's Low Price:$370.00
CJ's Low Price:$254.99