Ford Performance Tremec Magnum T-56 6-Speed Transmission with a 2.95 Ratio 1st Gear and 26 Spline Input Shaft for 1999, 2000, 2001, 2002, 2003 and 2004 Mustangs.
Looking for a beefy transmission for your 1999-2004 Mustang that you can take to the track and still be able to drive it home? Then take a look at this Ford Performance M-7003-M6295 Tremec Magnum T-56 6-Speed Transmission with a 2.95 Ratio 1st Gear and 26 Spline Input Shaft from CJ Pony Parts!
The T-56 is most easily swapped in 1999-2004 Mustangs but can be used in various Mustangs with the proper accessories. A 26 spline input shaft and 31 spline output shaft are featured which may require a different clutch and driveshaft yoke depending on your setup. Most engine combinations can be handled thanks to a 700 ft/lb torque capacity rating. The T-56 has provisions for both mechanical and electronic speedometers.
Fits SBF, 4.6L SOHC/DOHC and 5.0L Ti-VCT engines. SBF 302/351 engines require Quicktime bellhousing part # 8031 and modular 4.6L/5.0L/5.4L engines require bellhousing part # 8080.
1st - 2.95
2nd - 2.10
3rd - 1.46
4th - 1.00
5th - 0.74
6th - 0.50
*May require shorter driveshaft, modified crossmember/transmission mounts and other minor modifications.
If you're looking for parts for your 1964-2016 Mustang, you should start by looking at the plethora of Mustang parts that CJ Pony Parts offers from Ford Performance (formerly Ford Racing). By buying your Ford Performance parts from CJ Pony Parts, you know you're getting your Mustang parts from a reliable, reputable dealer, since CJ Pony Parts is a Top 10 Ford Performance Dealer and has been for the last 10 years.
Order this Ford Performance M-7003-M6295 Tremec Magnum T-56 6-Speed Transmission with a 2.95 Ratio 1st Gear and 26 Spline Input Shaft for your 1999, 2000, 2001, 2002, 2003 and 2004 Mustang from CJ Pony Parts today!
Similar Mustang PartsMore Restomod Transmission
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
will this fit into a 1969 mustang convertable?
Can this go into 1967 ?
I have a 1966 fb mustang rod and custom front end looking to put a 351 block 427 cu motor19 with lakewood bell need p/n and this trans?
Is it possible with upgrades for this to fit a Fox Body?
Will this fit in a 93 fox body mustang?
I have a 2001 SVT cobra would this fit properly if not what would I have to change
You Might Also Like
/** * Cases for simple product that is not on sale */ ?>CJ's Low Price:$3,250.00