Front Floor Support for 1965-1968 Coupe and Fastback Mustangs.This reproduction support is constructed of heavy 16GA stamped steel and runs from the front rail rearward under the floor pan.
Sold individually. Fits either driver or passenger side.
Product ReviewsWrite a review
Floor Support Front Coupe/Fastback 1965-1968 is rated out of 5 by 1.
Rated 5 out of 5 by Mr G from Canadian-made and heavy duty The factory supports were very wimpy and only 18g sheet metal. Was pleasantly surprised to find these floor supports are the heavier sheet metal (14g?). Haven't installed them, but their heavier construction makes me believe they'll be far better than the wimpy originals.
Date published: 2015-08-06
You Might Also Like
By Bill Tumas: We're here with a replacement floor support for you 65-68 Mustang Coupe or Fastback. The floor supports are going to weld to your front frame rail and tie in-between the floor pan and the cross member. These quite often rust out and many times they're damaged when people mistakenly jack up their car using the floor support. Here you can see a floor support installed on our 65 Mustang Coupe, we added front torque boxes to this vehicle so you can see how the floor support ties into the frame, the torque box, as well as supporting the floor and tying into the cross member. The floor supports are not going to be side specific. If you're looking to replace your floor pans in your Mustang, it's an excellent time to replace your floor supports as well.