Holley Polished Performance 500 CFM 2-Barrel Carburetor with a Manual Choke.
Are you in the market for a factory style carburetor for your 2-Barrel intake manifold? If so you might be interested in this performance carburetor from Holley. This carburetor is a direct replacement for all Ford Engines with a 2-barrel intake manifold. The Holley 500 CFM carburetor is manufactured to be installed on smaller displacement engines like a 260, 289 or a 302 Engine. When you purchase this carburetor, Holley wet-flow test every carburetor before shipping them out.
Holley installs a Polished Finish which gives it a performance appearance. With this carburetor being a factory style replacement Holley recommends you use this on a stock engine. The manual choke is cable driven and hand operated which makes for precise cold starts. The Holley carburetor has a 50cc accelerator pump that provides excellent off-idle performance.
- Polished Finish
- Intended as Stock Performance Replacement
- Manual Choke
- 50cc Accelerator Pump
- 100% Wet-flow Tested by Holley Technicians
Please Note: This Holley Carburetor will not work on Ford Vehicles with an AOD Transmission.
The carburetor on your Ford is a part that you rely upon to work. Without it, your Ford isn't going anywhere. That's why you want to make sure you get a high quality part when you replace or upgrade your carburetor, and no carburetor is going to have higher quality than the products from Holley. With more than a century of experience, and dozens of products available from CJ Pony Parts, you know you're getting the best.
Purchase a new Holley Polished Performance 500 CFM 2-Barrel Carburetor with a Manual Choke from CJ Pony Parts today!
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
Hi, I have a 351W engine (pre 1977) which is fitted with the original motorcraft 2v carburetor. The mechanical choke does not function and i am investigating a new carburetor . Will this carburetor fit on the engine? Or is there an alternative?
I would prefer an electric choke on this carb., can that be done and what parts will be needed?
I have a 78 power wagon original. I want to upgrade the engine some. Any suggestions on the type of two barrel carb I should consider?
Would this fit a 1978 171 ci v6 Mustang with a manual transmission?
Will this replace a 2bbl. on a 1973 351C.
Will this fit my 64 1/2 260 V8 engine? Thanks
Missing revolutions on the manual choke. I cannot adjust the fast idle speed more without consequences for idle speed. Can I "bend" the metal linkage where the fast idle screw is located to get it more aligned with the throttle plate ? More push ?
hi my last order was a Holley carburetor 4412S .. i need a fuel inlet fitting foe my gas line ...size..? o part number? i have on my engine 289 the original 2 v carb ist this the same fuel line ?
You Might Also Like
CJ's Low Price:$362.95
All of the Holley carburetors are going to be available in the standard finish shown here, the polished version, or a fully polished aluminum casing with your choice with electric or manual choke. No matter what kind of horsepower your Mustang is making, here at CJ Pony Parts we have the perfect Holley carburetor for your application.