Hood Molding Chrome 1967-1968

CJ's Part Number: HM2
CJ's Low Price:
$18.99
1416528000 17913
Earn 18 RPM Points What's this?
1416873600 1417392000
On Sale: Up to 30% Off Sale!
Hood Molding Chrome 1967-1968

Product Description

Chrome Hood Molding for 1967-1968 Mustangs.

This is a chrome original style replacement. Mounts on the edge of the hood above the grille. This will surely top off your new grille assembly.

Comes with mounting screws for an easy install.

Similar Mustang Parts

similar mustang parts More Mustang Hood Moldings  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Bad product
The slots for the screws are all off . I need drill a new hole for each screw. Fitment it terrible. To bad this is the only one that if offered for the 1967 Mustang, Scott Drake sells the same one.
Jim April 30, 2014
length is bad
On one side, the length is just right, but the other side, its about 2 inches too long. Overall besides that, its great, just really disappointing that apparently its too hard to cut it the right length.
les June 18, 2012
fitment sucked
its about 3/4 an inch to wide for the hood, and the holes on the whole RH side needed to be drilled out some to be able to slide it over a little to center it somewhat, still leaving about a 1/2 to a 1/4 inch hanging off the edge of the RH edge of the hood. Buy the more expensive ones!!!
Jake B May 13, 2012
Fit was off
Bought this to replace the hood molding on my 68 Coupe. When we fit it, we found that it was almost 1 inch too long for the hood. We shifted it as much as we could, but the fitting was rubbish to be honest. Apparently this is pretty much a common issue with these repro moldings, and i'd advise going for an NOS or Scott Drake unit which may cost more, but hey, its on the front of your car and needs to look good!
Luke Tabone March 9, 2012
Exact Replacement
Looks exactly like original. Fitment was excellent. No modifications required.
Don March 9, 2012
5 Results

You Might Also Like