Alloy Metal Products Horn Jumper Wire Drag Pack 1969-1970

Alloy Metal Products: 69-HRN JMPR
CJ's Low Price:
1454803200 39853
Earn 20 RPM Points What's this?
Alloy Metal Products Horn Jumper Wire Drag Pack 1969-1970
Alloy Metal Products

Product Description

Alloy Metal Products Horn Jumper Wire for all 1969-1970 Mustangs Equipped with the Drag Pack Option.

This Horn Jumper Wire from Alloy Metal Products will fit all 1969-1970 Mustangs equipped with external oil coolers. Included are the Boss 302, the 428 Super Cobra Jet as well as all Boss 429s. This AMP Horn Jumper Wire is a wiring harness extension used to connect the two horns after the driver's side horn has been relocated to make room for the oil cooler. The driver side horn gets moved to the passenger side of the radiator core support and this wire allows both horns to function, without the use of an additional wire feed. The remote oil cooler was added because of the higher rear gear ratio that produces more RPMs and subsequently higher heat and stress on the engine and engine oil.

The Drag Pack option featured a 3:91 or 4:30 rear end gear ratio, external oil cooler and relocated horn. There is a bracket in the radiator support behind the horns to support the horns being mounted side by side. This AMP Horn Jumper Wire (sometimes referred to as the "oil cooler jumper") is used to electrically connect both horns in this new position. If you have a 1969-1970 Mustang that has an external oil cooler and you haven't connected the two horns, then you need to pick up this Alloy Metal Products Horn Jumper Wire today from CJ Pony Parts!

*This jumper wire is also correct for other Ford, Lincoln and Mercury cars utilizing external oil coolers.

Similar Mustang Parts

similar Mustang parts More Horns  

Installation Instructions

Mustang Installation

Product Reviews

Write a review

Product Questions


You Might Also Like