Mustang Black Projector Headlight Kit (1999-2004) Installation Instructions

Tools Required:
  • 8mm Wrench/Socket
  • Small 90 degree Pick
Install Difficulty:
  • Easy
  • Easy Project
1. To start the installation of your new Mustang Black Projector Headlight Kit, remove the negative battery lead using the 8mm wrench / socket.
Mustang Black Projector Headlight Kit Install Image
2. Locate and remove the Mustang headlight retaining clips. There are 2 on each side. Lift straight up on them they just slide out. If they are tough, put some pressure on the front of the headlight and use the pick to help lift up on the clips.
Mustang Black Projector Headlight Kit Install Image
3. Pull the headlight straight out and give yourself enough room to access the 2 connectors on the back. One is for the headlight bulb and the other is the turn signal bulb. To remove the connectors GENTLY pry up on the clip and pull straight back. There is one on the top of the headlight connector, you might have to remove the factory Mustang headlight retaining ring to get to it, and two on the blinker connector. (If you aren't careful with the clips on the connectors they will break! I used the pick to help pry gently without breaking)
Mustang Black Projector Headlight Kit Install Image
Mustang Black Projector Headlight Kit Install Image
4. Remove the headlights and then transfer your stock turn signal bulbs from your old set to the new set. They come with new headlight bulbs already installed, so don't worry about those. To remove the turn signal bulbs you have to turn them 90 degrees and pull straight out. They re-install in the new lights the same way just line up the notches and rotate 90 degrees to lock into place.
Mustang Black Projector Headlight Kit Install Image
5. Install the new headlights into the headlight opening and leave enough room to reconnect the plugs. Tuck the wiring back into the headlight opening.
Mustang Black Projector Headlight Kit Install Image
6. Push the Mustang headlights back into place and make sure they are going in straight. You will feel when they are aligned correctly and once they are just push in and put a little bit of upward pressure on them to reinstall the retaining pins.
Mustang Black Projector Headlight Kit Install Image
7. Reconnect the negative battery lead using the 8mm wrench / socket and then test the new lights to make sure they are all working correctly. Enjoy your smoked look from the Mustang Black Projector Headlight Kit, without sacrificing light output!
Mustang Black Projector Headlight Kit Install Image