Mustang Procar Seat Track Adapter (1979-1998) Installation Instructions

Tools Required:
  • 15mm Socket & Deep Socket
  • Ratchet
  • 15mm Wrench
Install Difficulty:
  • Easy
  • Easy Project
1. To start the installation of your new Mustang Procar 81828 Seat Track Adapter, slide the factory seat all of the way backward and use a 15mm socket to remove the two 15mm nuts that are on the studs that go through the front of the factory bracket.
Mustang Procar Seat Track Adapter Install Image
Mustang Procar Seat Track Adapter Install Image
2. Slide the Mustang seat forward to access the bolts that hold down the rear of the factory seat bracket. Remove the bolts with a 15mm socket and ratchet. Note: If you have sub frame connectors with seat braces under the car, make sure you get the nuts that are fastened to the underside of the bolts.
Mustang Procar Seat Track Adapter Install Image
Mustang Procar Seat Track Adapter Install Image
3. Tilt the seat back and unplug the wire that connects to the bottom of the seat for the electric lumbar support.
Mustang Procar Seat Track Adapter Install Image
4. The seat is now ready to be removed. Pull the seat out of the car and set it aside.
Mustang Procar Seat Track Adapter Install Image
5. Place the new seat track adapter into place on the Mustang floor pan and line up the holes.
Mustang Procar Seat Track Adapter Install Image
6. Use the factory bolts and start them in the rear holes for the bracket using a 15mm wrench. Do not tighten them all the way down.
Mustang Procar Seat Track Adapter Install Image
Mustang Procar Seat Track Adapter Install Image
7. Pull the new Procar track so it is far enough away from the transmission tunnel to allow the new seat to be attached to it. Secure the front of the bracket by tightening the factory nuts on the studs using a 15mm socket and ratchet.
Mustang Procar Seat Track Adapter Install Image
Mustang Procar Seat Track Adapter Install Image
8. Tighten the front nuts and the rear bolts that attach the bracket to the floor. Note: Don’t forget to put the nuts back on the underside of the rear bolts to secure the sub frame seat braces.
9. The Mustang Procar Seat Track Adapter is now installed and you are ready to attach the new seat to the adapter.