Mustang Accel Ignition Coil Pack Set (1999-2004) Installation Instructions

1. To begin installing your new 1999-2004 Mustang Accel 140032-8 Ignition Coil Pack Set, pop the hood and disconnect the negative battery terminal. Then, use a flat head screw driver to loosen the air intake tube and move it out of the way. After that, you should be able to locate all eight of the factory coil-on plugs.
Mustang Accel Ignition Coil Pack Set Install Image
2. Remove the 7mm bolt that holds down each coil-on pack, and disconnect the electrical plug on each of the factory coils by squeezing the tabs on the connector. This will allow you to completely remove each of your factory coil-on packs from the Mustang ignition system.
Mustang Accel Ignition Coil Pack Set Install Image
3. Place your new Accel coil-on packs into each cylinder, opposite from the way the factory ones came out.
4. Install the 7mm bolts onto each of the new coil-on packs and reconnect the electrical plugs. Reinstall the air intake tube and reconnect the negative battery terminal. Start the car to make sure it is not misfiring. The installation of your new 1999-2004 Mustang Accel Ignition Coil Pack Set is now complete!
Mustang Accel Ignition Coil Pack Set Install Image
Mustang Accel Ignition Coil Pack Set Install Image