Painless Powerbraid Chassis Harness Kit.
Are you ready to install the wiring harness in your Mustang? Before installing the chassis harness make sure you protect the wires from getting damaged with this Powerbraid Chassis Harness from Painless Performance. This wire loom is a flexible, semi-rigid material, with a tough woven texture and appearance to enhance the look and protect the insulation of any electrical wire bundles or cables.
This Painless Powerbraid Chassis Harness is constructed out of tightly woven material. Its smooth texture will make your Mustangs wiring system look like it just come off the showroom floor. The woven material helps block out unwanted debris that can occasionally damage you’re wiring electrical system. This wire loom is so easy to install using a lateral split design which has a 25 percent minimum overlap.
- 1” PowerBraid (6 Feet)
- 3/4” PowerBraid (10 Feet)
- 1/2” PowerBraid (30 Feet)
- 1/4” PowerBraid (60 Feet)
- 1/8” PowerBraid (15 Feet)
- 3/8” Heat Shrink (2 Feet)
- 1/4 Heat Shrink (1 Foot)
- 1/2 Heat Shrink (1 Foot)
- 4in. Tie Wraps (100)
- 7in. Tie Wraps (40)
- Electrical Tape(1 Roll)
- Stretch and Seal Tape (1 Roll)
- Continuous Temperature Rating -94° to 257 °F
- Melting Point 482°F
- Overlap Wire Loom Design
- Easy to Install
All of the products from Painless Performance are engineered for your specific application, and come from Painless Performance well manufactured and grouped so you can have a much easier time installing them. Each Painless Performance product is also pre-tested, so you can have peace of mind that it will work when it arrives at your door. CJ Pony Parts offers dozens of Painless Performance parts.
Purchase a Painless Powerbraid Chassis Harness Kit from CJ Pony Parts today!
Similar Mustang PartsMore Clips, Retainers & Grommets
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
You Might Also Like
CJ's Low Price:$649.99