Pitman Arm for 1967-1970 Mustangs with Manual Steering and a 1-1/8" Sector Shaft.Replace your old or broken pitman arm with this quality reproduction and get your Mustang rolling again!
The pitman arm attaches to the steering box sector shaft and the steering center link to translate the angular motion of the sector shaft into the linear motion needed to steer the wheels.
This replacement pitman arm fits a 1-1/8" diameter sector shaft and includes the required castle nut and cotter pin.
*If your 67 Mustang with manual steering has a 1" sector shaft, use part number PA1.
Product ReviewsWrite a review
Pitman Arm Manual Steering 1-1/8" Shaft 1967-1970 is rated out of 5 by 1.
Rated 5 out of 5 by Kiwi Ray from Borgeson 800111 change over Used it in my 67 Fastback to replace the old power steering setup with the Borgeson: 800111. My old power steering box was 1 inch shaft (I did not know this when I brought the gearbox) so i needed the center link plus the 1 1/8 Pitman arm plus the idler to complete the change over....it works super great now
Date published: 2015-05-06
I have a 67 Mustang manual steering with the late steering box, with rag joint. Will this pitman arm be the correct one?
Yes this would be the correct part.
Date published: 2016-04-22
Pitman Arm Manual Steering 1-1/8" Shaft 1967-1970. Will this fit the 1963 falcon ranchero V8 with 1-1/8" shaft?
The vendor has not provided any information regarding cross-fitments of this part to any other model then what is listed.
Date published: 2016-01-12
You Might Also Like
CJ's Low Price:$171.99
CJ's Low Price:$370.99