Pop Open Gas Cap Kit with Running Horse Logo for 1968 Mustangs.
When upgrading or replacing the fuel filler cap on your 1968 Mustang, consider upgrading to this Pop Open Gas Cap Kit with Running Horse Logo, now available here at CJ Pony Parts!
This upgraded direct-fit gas cap is an external pop open lid that has a brushed satin center with a chrome outer ring. It swings down to reveal a standard twist-off fuel filler tube cap. The mounting frame/bezel features a chrome plated finish and the entire kit is frame by the beautiful Ford-licensed Running Horse logo in a gleaming chrome Corral. This kit contains all the pieces necessary to upgrade from a screw-off type cap, or to replace an existing pop open style fuel cap. You won't need anything else, just this kit and a new fuel filler pipe. Order yours today from CJ's!
Whether you’re looking for an exterior mirror, wheels and tires, headlights and taillights or a set of interior upholstery, CJ’s has the parts you need to complete your classic Mustang restoration with ease! CJ’s has the parts you need to bring your early model Mustang build back to life--browse our huge selection of restoration parts for your pony today!
Order this new Pop Open Gas Cap Kit with Running Horse Logo for your beautiful 1968 Mustang from CJ Pony Parts today!
Product ReviewsWrite a review
You Might Also Like
CJ's Low Price:$106.99
These are all the parts that are included in pop open gas cap kit for the '69 Mustang. It actually gives you two options as far as how to mount it. The pieces over here for the original pop open style; if you want the look without the pop open function; they include a gas cap as well. We are going to show you how to assemble it before we install it on the car.
For this installation we used a regular Philips-head screwdriver, a small tip Philips-head screwdriver and a pair of needle-nose pliers.
The first step in the assembly is to mount the emblem. You'll line up the holes and press in. You will use the retaining washes and put them on the back to keep it in place. You will use the pair of needle-nose and crease them just slightly before you put them on so that they fit tight.
The next step is the spring. It's gonna go on the door right over the clips we just installed. I'm going to grab the cap itself. You want to put the washer in the center. Now put the screw in the center. Then, push down on it while tightening. Next, we'll install the gasket over the cap here. Make sure you line up the holes. Now we'll install the cap and the retaining screws. Now our cap is ready for installation.
Our '69 Mach 1 came with factory pop-open gas cap, but, like the rest of the car though, it could use a little bit of brightening and so we are going to install our new gas cap. The first step, pop open the gas cap and remove the retaining screws. Once you have all the screws out, grab the bottom and give it a little tug and it'll come right off. We are going clean it up a little bit before we put the new one on. We are now ready to install our new cap. The four screws on the outside were removed. This stud here is for a fifth screw that comes from the inside to make it so no one can steal your cap. We'll install the outside ones first. You can reuse the original hardware or we do offer new hardware as well. Now, you are ready to install the last screw from the trunk and our installation is complete.
Remember, if you chose to use the pop-open assembly, you do not use the gas cap that is included in the box. Our new pop-open gas cap really glows on the back of our otherwise original '69 Mach 1. You will probably spend more time assembling the cap then it actually takes to install it. Figure no more than 20 minutes for the whole process. You'll be back on the road in no time.