Quarter Panel Skin with Ornament Holes for 1967 Mustang Coupes and Mustang Convertibles.Our quarter panel skins include the complete lip into the door jamb and wheelhouse area.
*We recommend full quarter panels for fastback owners. If you attempt to install this skin on a fastback you will need to stay several inches below the top body line.
Similar Mustang PartsMore Mustang Quarter Panels
This product will fit the following Ford Mustang years:
I have to agree with the other reviewers. I experienced the same measurement differences during my install. The C scoops are too high by about 1/2 inch throwing off ALL body lines. The panel is about 1/2 inch too long giving you a large bag and making either front or rear welding tabs unable to fit, and the bottom rear that should match up to the trunk drop down is WAY off. I dont even know how to describe it...its just a totally different shape. DO NOT order this product unless your budget will not allow for anything else and you are a decent metal fabricator. I am in the middle of my install right now and am thinking I will have to give up and order a full 1/4 because there is just no way to make this piece fit.
these fit really awful! No chance that they fit with out heavy adjusting and cutting etc. My mechanic has done several hours work just to get them even close...please buy the more expensive parts if you dont want to pay extra for installing these junk ones.
hi. bodyman for over 50 yrs never had a part fit this bad. (awful)
I attempted to install this for the passenger's side and it was a joke. There is no recess in the back for the valance, and it completely misses where the trunk extension drop down curves up by almost 3/4 inch. The skin was too long so the lip that goes on under the quarter extension sat off it about 1/4 inch. At the front, when sitting flush on the rocker, the C scoop wanted to angle up and both body lines were about 1/2 inch off those of the door. If I pushed the panel down so the body lines on the C scoop lined up with those of the door, then the bottom of the panel sat below the top of the rocker panel mounting surface. If you popped it back onto that then your C scoop goes back to being completely messed up. Surprisingly enough, the wheel house radius was the only thing correct about this panel. Save yourself the headache and do not get this skin. I replaced a full quarter on the driver's side, part also from CJ's, and the panel looked correct and fit pretty well. If you only need to do a skin, ord
You Might Also Like