I attempted to install this for the passenger's side and it was a joke. There is no recess in the back for the valance, and it completely misses where the trunk extension drop down curves up by almost 3/4". The skin was too long so the lip that goes on under the quarter extension sat off it about 1/4" inch. At the front, when sitting flush on the rocker, the C scoop wanted to angle up and both body lines were about 1/2" off those of the door. If I pushed the panel down so the body lines on the C scoop lined up with those of the door, then the bottom of the panel sat below the top of the rocker panel mounting surface. If you popped it back onto that then your C scoop goes back to being completely messed up. Surprisingly enough, the wheel house radius was the only thing correct about this panel. Save yourself the headache and do not get this skin. I replaced a full quarter on the driver's side, part also from CJ's, and the panel looked correct and fit pretty well. If you only need to do a skin, ord
hi. bodyman for over 50 yrs never had a part fit this bad. (awful)
these fit really awful! No chance that they fit with out heavy adjusting and cutting etc. My mechanic has done several hours work just to get them even close...please buy the more expensive parts if you dont want to pay extra for installing these junk ones.