Scott Drake Fan Shroud Plastic 3-1/2" Wide 260/289 1965-1966

Scott Drake: C3DZ-8146-3
CJ's Low Price:
1419724800 14801
Earn 90 RPM Points What's this?
FANS11 Play Scott Drake Fan Shroud Plastic 3-1/2 Play Scott Drake Fan Shroud Plastic 3-1/2

Product Description

Scott Drake 3-1/2" Wide Plastic Fan Shroud for 1965-1966 260/289 Mustangs.

This new & improved fan shroud from Scott Drake is for the 65-66 8-cylinder Mustangs and is efficient in drawing in cool air through the radiator at low speeds and idle, which is when most overheating occurs. This shroud is 3 1/2" wide.

Not only does this larger shroud greatly enhance cooling capabilities, it also offers more protection from the fan blades. Made from ABS plastic.

*65-66 6-cylinder Mustangs can use this shroud with minor trimming.
*Fan shroud brackets sold separately.

Similar Mustang Parts

similar mustang parts More Mustang Fans & Fan Shrouds  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
Overall Good Product
The fan shroud took some tweaking as allready mentioned. I found it easier to remove the radiator and slip the shroud over the fan. I avoided skinned knuckles as well as not running the risk of poking a hole or two in the radiator. Entire job took a little over an hour. Really helps in cooling, looks good also It may be helpful if the shroud had a sticker showing the top.
Bill October 22, 2014
Well worth it
It may be helpful if there were a label showing the top of the shroud . I found it easier to remove the radiator and install the shroud over the fan. #1 no need to remove the fan, #2 don't run the risk of damaging the radiator ( and skinned knuckles replacing the fan) As above, it took a little tweaking but works just fine
Bill October 9, 2014
This shroud looks good and is well made. It took quite a while to fit because its a fiddly job.

There was only a quarter of an inch clearance round the six blade thermo fan, so some tweaking is required.
Frederik July 1, 2014
Shroud looked really good. Just need to note the size on the description to help from ordering the wrong one.
David April 25, 2014
Shroud works well and looks correct
Shroud required some adjustment to the holes to center exactly so I could run a larger fan w/cluch, but not a big deal.
Brak65 April 21, 2013
5 Results

You Might Also Like

Product Video

By Bill Tumas: We’re here with a high performance 3 1/2-inch fan shroud for your 1964 through 1966 small block Mustang from Scott Drake. This 3 1/2-inch ABS fan shroud is 3 1/2 inches deep, which does a great job of drawing air in at idle, which is when your Mustang has its biggest problems with overheating. It's designed to fit your '64 through '66 small block Mustang, but will also fit the six cylinder with minor trimming. This 3 1/2-inch fan shroud is a great way to aid minor cooling issues in your '64 through '66 small block Mustang.