Scott Drake Programmable Sequential Taillight Kit for 2005-2009 Mustangs.Easily add style to your Mustang or Shelby with this easy to install sequential taillight kit from Scott Drake. This kit includes two complete harnesses to replace your stock ones with no cutting or splicing required. Features five programmable settings so you can customize your look.
Similar Mustang PartsMore Taillights
Product ReviewsWrite a review
I purchased a sequential tail light kit for my 2008 Mustang and find that the lights flash to fast. Is there a way to slow them down so they project that true retro look?
Can LED Taillights be used with this upgrade?
hello, i want to buy this taillght kit but i life in germany. can i buy this? can you send me this? how mutch must i pay in € or in $? thaks for your answer
I installed my set of lights. They are set to the default setting (off, off, off) and it looks like the 3rd light comes on a split second before the second light comes on... Is there a correction for this?
You Might Also Like
From:CJ's Low Price:$75.99
CJ's Low Price:$129.99
The includes two plug and play harnesses, as well as detailed instructions. The harnesses are not side specific, but are numerically numbered for proper installation. This switch here is unique to Drake Muscle Cars and allows for six different sequencing options.
For this installation, we'll need a quarter inch ratchet, 11 mm deep socket and a small pick. The installation requires us to pull the taillight bodies off of the car. The first step is to remove these plastic trim panels from inside the trunk. Start by unthreading this one here. To pop these clips out, we need a small pick. Pull up and put the panel aside. Now you want to disconnect the taillight harness by pushing down on the clip and simply sliding it upward. Now, were going to remove the three retaining nuts that hold the taillight to the body. Now we're going to push the harness through down here. We carefully push against the studs of the taillights and remove our taillight.
Once you have your taillight out, we're going to remove the factory harness. Turn the bulbs to release them. Now were going to move the bulbs over to the new harness. The sockets are numbered, so they sequence properly. One's going to be on the inside, two, then three will be on the outside. Now we're ready to reinstall our light. You're going to reinstall the same way you took it out. Fish the harness through first. You want to make sure you get the harness pushed through and seated before you put the taillight up into place. Now we're going to reinstall the retaining nuts. Make them snug; you don't want to crank to tight on them. Now we're going to want to plug our harness back into the original wiring.
Once you plug in the harness, you can turn on the hazard lights to check our lighting. This is going to be the default sequence out-of-the-box. If you want to make a change, you simply change the dipswitch location on the harness itself. The instructions come with a detailed diagram showing you, which switches do what.
Once you've tested your light, you're ready to reinstall your trunk trim panel and your installation is complete. The adjustability of our Drake Muscle Car Sequential Taillight Kit gives our '06 a really unique look with the lights turned on. Installation should take you no more than a half an hour; you'll be back on the road in no time.