Outer Shock Tower Cover for 1965-1966 Mustangs.This is a reproduction shock tower cover that bolts to the inner full shock tower covering the coil springs. The upper control arm bumper attaches to the bottom side of this cover.
Don't waste your time with these. In order to use them you would have to hammer them into shape and drill new holes.
This Shock Tower is a Stamping from a single sheet of metal. Meaning you have creases and folds That not only look bad but distort the shape of the original look of the product. NONE- of the pre-drilled holes even came close to lining up. The Bumpstop is not included and used my original. The Bumpstop has a liped shackle molded into it that has to hang over the lip of the Chock Tower cover... The problem is the cover is formed so out of sync from the original that I, you have to cut a section out for the Bunpstop lip to lye into. There ends up being way to much work on this thing, knowing you can spend 20 buck more and just bolt it in... DO NOT Waste Your Money... No to see if CJ will refund my money after my modifications to it.
You Might Also Like
CJ's Low Price:$12.99
CJ's Low Price:$50.99