Eastwood High Temp Coating Kit with One Pint of Matte Silver.Eastwood's matte silver high temp coating is a simple alternative to expensive ceramic coating. The high temp coating is your ideal choice for durability and good looks on headers and other areas of extreme heat. Once fully cured, the silver finish can withstand up to 1,200° Fahrenheit. Your engine's heat is used to cure the paint.
Includes three poly-foam brushes.
Product ReviewsWrite a review
Eastwood High Temp Coating Kit Pint Matte Silver is rated out of 5 by 9.
Rated 1 out of 5 by 67Mustang from Don't waste your time and money Sandblasted and prepped the headers like recommended only to have them start rusting after having run the motor less than 10 times. Very disappointed in this Eastwood product.
Date published: 2014-12-20
Rated 1 out of 5 by 69Geeto from Blisters over earlier product I freshen up the manifolds every winter with Eastwoods older version of this paint. Has worked flawlessly in the past. This new version, goes on fine, looks great, until the manifold gets hot. It then blisters off. Might be good on a fresh manifold, but no go for a refresh!
Date published: 2015-01-24
Rated 5 out of 5 by Doctorj from 1965 Corvette.... I bought this product at the suggestion of the salesperson from whom I purchased the vehicle last fall. I applied to the exhaust manifolds and touch-ed up parts of the intake manifold....and even the master cylinder.!!..so far so good after a few hours of operation....though from what I have read, areas will need to be touched-up in the future.
Date published: 2015-05-10
Rated 4 out of 5 by Ken _H from Pretty Good My manifolds are in great shape on my Chevelle, what I bought this paint for was to cover my pipes and mufflers. The paint covered great and I still have 1/3 can left. My only complaint would be the sponge brushes supplied. 1 brush wont go into the can, 1 brush is too small to do much and the main one I used fell apart about 1/4 way through.
Date published: 2015-03-22
Rated 4 out of 5 by Cousin Mike from Product was as described. Coated my stainless steel headers with it to give finish them up. Applied a few coats and had plenty of the paint left over for touch up. Looks good.
Date published: 2015-07-19
Rated 5 out of 5 by FLY BOY DAVE from HEADER PAINT I used it on my Helicopter exhaust pipe and wrap. Best stuff! My muffler glows orange and it still has held up after a year and still going.
Date published: 2015-12-10
Rated 5 out of 5 by Ed63falcon from Worked well for me. I blasted my exhaust manifolds and coated them with this like the directions said. So far so good
Date published: 2016-07-18
Rated 5 out of 5 by Pavement runner from Goes on great , covers well I just applied this product , it goes on smooth and covers well in one coat
Date published: 2016-06-18
You Might Also Like