SSBC Caliper Kit Quick Change Competition Street Clear Anodized 1968-1973

SSBC Brakes: A213
MSRP: $554.95
CJ's Low Price:
$549.99
1467158400 1406
Earn 549 RPM Points What's this?
SSBC Caliper Kit Quick Change Competition Street Clear Anodized 1968-1973
SSBC Brakes

Product Description

SSBC Quick Change Competition Street 4-Piston Aluminum Caliper Kit for 1968-1973 Mustangs with Factory Disc Brakes.

If your Mustang is equipped with factory disc brakes and you're looking for an inexpensive upgrade, this is the ticket! SSBC's Quick Change Competition Street 4-Piston Aluminum Caliper Kit is designed to replace OE single piston calipers. SSBC's calipers are constructed from 6061 T6 billet aluminum and assembled with stainless steel pistons and bleeder screws.

Featuring 25% more pad contact area than other calipers and 20% thicker pads than other calipers with this mount. Dual pad pin design with o-rings to eliminate pad chatter. Uses an off the shelf D43 pad available at any local parts store. Will fit both 7/16" & 3/8" brake hoses.

100% Made in USA.

Available in a Clear Anodized, Polished, Black or Red Powder Coated Finish.

*Requires minimum of a 15" wheel.

OTHER APPLICATIONS
Fits 1968-1973 Ford Fairlanes
Fits 1968-1973 Ford Falcons
Fits 1968-1973 Mercury Comets
Fits 1968-1973 Mercury Cougars
Fits 1968-1973 Mercury Cyclones
Fits 1968-1973 Mercury Montegos

Similar Mustang Parts

similar Mustang parts More Restomod Brakes  

Installation Instructions

Mustang Installation

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a review
SSBC Caliper Kit Quick Change Competition Street Clear Anodized 1968-1973 is rated 5.0 out of 5 by 1.
Rated 5 out of 5 by from ssbc kwik change calipers. beautifully made calipers.shame to put them on the car.look nice in a display cabinet.only niggle is the adaptors for the flex hoses wont screw in to the caliper.the hole in caliper is 1/8 npt.thread on adaptor looks bigger.wont screw in.banjo bolt thread is 3/8-24.this will start to thread in 1/8 hole but stops after a few threads. i know this aint right.adaptors are zinc coated i think???.perhaps the threads need a tap ran down them.not the sort of hiccups you expect from a company like ssbc.apart from that very happy.
Date published: 2016-02-15
  • 2016-06-29T08:58CST
  • bvseo_cps, prod_bvrr, vn_cps_3.2.1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_1
  • loc_en_US, sid_A213, PRD, sort_relevancy
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.1.0
  • CLOUD, getContent, 201.7ms
  • REVIEWS, PRODUCT

Product Questions

  • bvseo_sdk, p_sdk, 3.1.0
  • CLOUD, getContent, 105.23ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: HTTP status code of 403 was returned;

You Might Also Like