Steeda Cold Air Intake Kit Proflow Manual GT 2010

Steeda: 5553152
CJ's Low Price:
1432339200 479
Earn 414 RPM Points What's this?
5553152 5553152_1 5553152_2 5553152_3 5553152_A

Product Description

Steeda ProFlow Cold Air Intake Kit for all 2010 GT Mustangs With a Manual Transmission.

Steeda started this ProFlow Cold Air Intake Kit with a large surface area, high flow air filter and attached their famous velocity stack to it. They then designed a black heat shield with a rubber gasket to seal against the hood and keep out heated air from the engine compartment from being inducted into the engine.

They increased the MAF housing size to 95mm and then coupled it to a new higher flowing Pro-Flow inlet hose. This larger induction system will fit directly in place of where the original intake system was located and will be sure to bring clean, cold air directly into the engine of your 2010 GT Mustang with a manual transmission.

- Easy bolt-in installation
- Retains sound tube and factory cold air ducting
- Gains of up to 25 HP at peak
- Power increase at all RPM ranges - not just peak power

You would think that this is more than enough, but Steeda went the extra mile and designed this cold air intake system to accept the factory sound tube, should you choose to want to keep it. They also have tied their air-box into the factory lower cold air scoop for the induction of the coolest air charge possible to your 2010 GT Mustang with a manual transmission's engine.

Similar Mustang Parts

similar mustang parts More Mustang GT Cold Air Kits  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a review

Product Questions


You Might Also Like