Similar Mustang PartsMore Paints & Dyes
This product will fit the following Ford Mustang years:
Product ReviewsWrite a review
Tank Tone Fuel Tank Paint By Eastwood is rated out of 5 by 15.
Rated 1 out of 5 by JoeSout from Improve spray Purchased 2 cans both cans spit out paint and provided a poor finish
Date published: 2015-02-06
Rated 4 out of 5 by rust bucket from Nice finish I made my own tank and wanted it to look factory. I do suggest priming, Used an epoxy gray for base. Shake well even as you are using, if concerned about drips wipe nozzle as you use it and keep finger towards rear of nozzle. Sounds stupid but it is a harder to push on this can. Go easy on coverage, I found good results by many light coats. It appears to be blotchy but when dries it is uniform. This paints on similar to cast iron color paint, don't concentrate heavy in one area. I was very pleased with the results. Just take your time.
Date published: 2016-04-03
Rated 3 out of 5 by flippermtc from Good for use on existing tank If you do not have a NEW GAS TANK, then this is the next best thing. If the existing tank still operates fine, this is a whole lot less money. Finish was acceptable & coverage okay.. As to operation at first the can worked fine & then it began to sputter & trip when it was below the half full line. Had to purchase a second can which Eastwood discounted 10% when I made them aware of the problem.
Date published: 2016-06-13
Rated 5 out of 5 by Motor City 62 from Nice Color If you do not have a NEW GAS TANK, then this is the next best thing. It is about the closest color for a gas tank that is available on the market today. Of course I prefer the galvanized look of a new gas tank, but if the existing tank still operates fine, this is a whole lot less money. Also, not all gas tanks are available as a reproduction so this is the next best thing.
Date published: 2014-12-11
Rated 4 out of 5 by Elp 54 from Metallic Tank Coating for the first seconds, the paint sputtered out of the can but after that it went on smoothly, no runs, no fisheye. Was pleased with the finish it gave the tank, looks original and didn't change the color much from the bare metal. I used this product on a new, replacement tank. will purchase another can to touch up as it got some scratches when installing it.
Date published: 2015-10-16
Rated 4 out of 5 by dcairns560 from So far so good! Used this product on a 57 Chevy gas tank. This paint looks a bit blotchy when its first sprayed but once it dries it looks really nice with a uniform color. Cant say how it will look after a few years but so far I am very pleased. Did not have any issues with the nozzle clogging or spattering as other reviewers have stated.
Date published: 2015-12-30
Rated 2 out of 5 by Tommy K from Disappointing I sand blasted my tank and applied 3 coats of the tank tone. I did not prime as it says in the description, no priming necessary. Surface rust appeared in 3 months. I now will have to apply rust converter and spray the tank again. I have been satisfied with most Eastwood products. Not this on.
Date published: 2014-10-10
Rated 2 out of 5 by Crazybones from tank tone covers well, looks great the only draw back is that you better buy plenty, every can I've purchased starts to spit about have way through and then you have drips. I don't know what I'm doing wrong, but it's the only spray can I have trouble with.
Date published: 2016-02-01
You Might Also Like