Ford Water Temperature Sending Unit for all 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1872, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994 and 1995 Mustangs Built After September, 1 1965.
If the temperature gauge in your 1965-1995 Mustang doesn't seem to be working quite like it should, it's more than likely a faulty water temperature sending unit. This new Ford Water Temperature Sending Unit is a direct-fit replacement for your damaged or missing unit and will provide proper readings to your temperature gauge once again.
This brass water temperature sending unit threads into the intake manifold and sends the information to the temperature gauge in the interior of your Mustang. Without a properly working temperature gauge, you run the risk of overheating the engine which could break the bank.
- Brass Construction
- OEM Replacement
- Wire Mounting Stud
- Correct 3/8"-18 Thread Size
*Some aftermarket intake manifolds may have a larger thread size for the water temperature sending unit. Please verify thread size before ordering.
The Ford Mustang consists of thousands of different parts. Throughout every generation of the car, the Ford Motor Company has made many of their Mustang parts internally, meaning if you're looking to replace a part on your Mustang, there's no better source than the OEM parts from Ford. CJ Pony Parts offers hundreds of parts from Ford for all years of Mustang, so you should have no problem finding exactly what you need.
Purchase a Ford Water Temperature Sending Unit for all 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1872, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994 and 1995 Mustangs Built After September, 1 1965 from CJ Pony Parts today!
Similar Mustang PartsMore Sending Units, Switches & Wiring
Product ReviewsWrite a review
Recently bought a temp sending unit for a 1966 Mustang with a gauge and installed it. The gauge did not function. I grounded the sending unit connector and the gauge pegged to hot indicating the gauge and wiring is operational. Any suggestions?
Is this the correct temp sending unit for use on 65 Shelby Al intake?
Is this sending unit for a v8 ?
I'm also interested in the answer to the question above: will this sending unit fit an Edelbrock Performer 2121 intake manifold?
What is the ohms rating on the OEM Temperature sensing unit for the 302 mustang engine?
Does it include the wire? If not do you carry the wire?
Will this fit the port on an Edelbrock Performer 2121 intake manifold?
You Might Also Like
CJ's Low Price:$11.99
Regular Price: $24.99
Special Price: $17.49
CJ's Low Price:$6.99
CJ's Low Price:$4.99