Pair of TMI Aqua/Turquoise Sport Series Headrests for 1965, 1966 and 1967 Mustangs with TMI Sport or Sport II Series Seats.Add some style and added safety to your Mustang with these aftermarket headrests. Features premium vinyl which perfectly matches TMI Sport Series and Sport II Series upholstery. TMI headrests are bolt-on parts with no cutting or welding required. Four position ratchet allows you to adjust the headrest to perfectly fit you. Plenty of colors are available to help you achieve the perfect interior combination.
Make your Mustang stand out from the rest by completing your seats with matching headrests. Not only do the headrests look great, but they are very comfortable and increase safety. TMI Sport Series headrests are the perfect addition to your TMI Sport Series or Sport II Series seats.
Available in all factory original colors. The year range listed after a color denotes what years the color is correct for.
You Might Also Like
Regular Price: $299.99
Special Price $269.99
For this installation you'll need a panel removal tool, 3/16 Allen key, a pick or an awl, razorblade, flashlight. If you have to modify your seat frame, you'll need a drill and a 5/16 drill bit and safety glasses. We have the seat out of the car to make it easier for you to see the installation. While it's easier to have them out, you actually can do it inside the car if you don't feel like removing your seat.
The first step is going to be to remove the seatback. The seatback is held on by door panel stock clips. Simply pop them up with your panel removal tool. Carefully work your way around the outside edge. We'll put that aside. This is a bracket for the headrest. We removed the hog rings from the top of our upholstery so you can get a better view of actually what we're doing. You don't have to do this for installation. This would make it easier for you to see. The bracket is going to slide in. You're going to put bolts from these two holes to hold the bracket in place. These holes are already open in the upholstery.
This is where the two of your top clips go for your seatback. On some seats provided hardware may not fit through the hole properly. If that's the case, you want to grab a 5/16 drill bit and open up the holes. We can install the brackets and install the hardware. We'll install the nut on the back and tighten them down. Now you want to grab an awl or a pick. I'm going to go straight up through the bracket to where it's installed and go straight up through these holes and poke holes through your seat foam and your seat upholstery. Now you want to find the holes and have a sharp knife and make an "X."
I'm going to cut a little bit smaller the first time. You can always open it up a little bit if you have to. If you cut too much off it's not going to look great. There's two different plastic inserts that come with each side. One has this little release which will allow you to adjust the height. We're going to install that one first. I'm going to make sure this lever is facing towards the inside of the car and the metal tab is at the bottom so the seat will release properly. I find it's best to use something like use your awl or another tool, come up from the bottom to line the hole up. Widen that over and then work it down into place. We're going to be going through some foam and the material you cut out that can take a little bit of work sometimes to get it into place. Before we put the seatback back on, we're going to install the headrest, make sure it works properly and clears back there and move it up and down, straight up and down or ratchet it. We're ready to reinstall our seatback. Line up all these original holes and push the clips back in.
The headrests do a great job with finishing off our Sport seat. The adjustability should make them comfortable for everybody, plus the added security is also nice as well. Installation will take you around an hour per seat. You'll be back on the road in no time.