Total Control Products Bump Steer Kit Manual Steering 1970-1973

Total Control Products: TCP TIER-10
CJ's Low Price:
$199.99
1481068800 50663
Earn 199 RPM Points What's this?
Total Control Products Bump Steer Kit Manual Steering 1970-1973
Total Control Products Bump Steer Kit Manual Steering 1970-1973 Play Total Control Products Bump Steer Kit Manual Steering 1970-1973 Video 1
Total Control Products

Product Description

Total Control Products Bump Steer Kit for all 1970, 1971, 1972 and 1973 Mustangs with Manual Steering.

Use this Bump Steer Kit from Total Control Products to reduce the amount of toe from your 1970-1973 Mustang's manual steering, thereby improving the consistency and predictability of the handling. This upgrade is a must for those looking to get improved performance and responsiveness from their Mustang.

Bump Steer Kit Includes:
- Adjustable outer tie rod ends
- Shim spacers
- Billet-steel adjuster sleeves

Most evident on rough road surfaces, during sharp cornering or under heavy braking, bump steer is the change in “toe”, or left to right angle, as the suspension moves through its range of motion. Toe can be measured by the difference in the track width of the leading edge and trailing edge of a set of tires, and the lesser the amount of toe the better in regards to performance.

With proper installation and settings, the Total Control Products bump steer kit can minimize and in some cases practically eliminate the bump steer affect in your 1967-1969 Mustang, delivering an impressive upgrade that can be immediately felt behind the wheel.

Please Note: This bump steer kit requires the use of V8 spindles and inner tie rods, and 11/16-18 (.688) thread on adjuster sleeve shaft. This bump steer kit will not fit the 3/4-18 factory power steering inner tie rods.

Purchase a Total Control Products Bump Steer Kit for your 1970, 1971, 1972 or 1973 Mustang with Manual Steering from CJ Pony Parts today!

Similar Mustang Parts

similar Mustang parts More Mustang Parts  

Installation Instructions

Mustang Installation

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a review
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 134.65ms
  • REVIEWS, PRODUCT
  • bvseo-msg: HTTP status code of 404 was returned;

Product Questions

  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 142.52ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: HTTP status code of 403 was returned;

You Might Also Like

Product Video

Total Control Products Bump Steer Kit Manual Steering 1970-1973 Video Transcript
By Bill Tumas: We’re here with a Total Control Products Bump Steer kit, fitting your 1970 through 1973 Mustang with manual steering. This Bump Steer kit from Total Control Products is going to replace the outer tie rod ends on your 1970 through 1973 Mustang with manual steering and address a common bump steer issue, especially with lowered cars. The kit includes 2 billet adjuster sleeves, as well as the adjustable ends, all necessary shims and hardware for installation. Bump steer is typically caused by a change in toe due to suspension movement. The more that toe changes, the more erratic the steering gets, it can actually get to the point where it's very dangerous. This kit will address and correct that issue and will require an alignment when installed. Due to differences in outer tie rod end diameter, this kit will only work with a manual steering car. It will not work with power steering.