Total Control Products Subframe Connector System Package for 1965, 1966, 1967, 1968, 1969 and 1970 Convertible Mustangs.
When looking to stiffen up your 1965-1970 Mustang's chassis, look no further than Total Control Products' Subframe Connector System Package. The package includes a pair of weld-on subframe connectors, a bolt-on center support.
- 1-5/8 x .134” round tubing subframe connectors
- 1-5/8" x .134" round tubing center support
- Tightly follows undercarriage sheet metal
- Fully sealed construction
- Black powder coat finish
- Room for 3" dual exhaust
Subframe connectors strengthen the unibody by connecting the front frame rails to the rear frame rails. 1-5/8 x .134” round tubing is fully sealed with 7 gauge formed sheet metal mounts. Front and rear mounts are placed to weld at the strongest points of the factory subframe. Mounting holes are pre-drilled for simple installation of the TCP center support.
Tying the subframe connectors together is a bolt-on center support constructed from 1-5/8" x .134" round tubing. This diagonal cross brace is held on with grade 8 hardware. Two 7 gauge mounts are slotted to allow for chassis variances. A shim set is included to achieve a perfect fit every time. The support is angled, sitting 1-1/2" below the forward factory subframe at its lowest point to allow for added exhaust clearance. Both the mounting tab and bracket are constructed from 1/4" thick mild steel and secured with grade 8 fasteners.
All parts are powder coated black and all necessary hardware is included.
- Pair of weld-on subframe connectors
- Bolt-on center support
Please Note: Custom exhaust may be required.
*The center support has a mounting bracket for a TCP standard 33" length torque arm.
|Fits 1967-1970 Mercury Cougar (Hardtop)|
Similar Mustang PartsMore Restomod Chassis Stiffening
Product ReviewsWrite a review
You Might Also Like
CJ's Low Price:$319.99
CJ's Low Price:$379.99
CJ's Low Price:$339.99
CJ's Low Price:$410.99