Front Outside Snap Universal Joint for 1965-1973 Mustangs.The u-joint is a service replacement part that is commonly overlooked and is a critical piece to replace during service on your front axle. It is a cross shaped connector that has to endure changes in speed and road condition during driving. A warn u-joint can lead to bigger problem in the front axle if not taken care of properly.
Replacement U-Joint for the following rear applications:
- 1965-1967 200,289 A/T
- 1968-1969 250, 302, 351 AT/MT
- 1970-1973 with 3 1/2' Yoke Out
Product ReviewsWrite a review
Universal Joint Outside Snap Front 1965-1973 is rated out of 5 by 1.
Rated 4 out of 5 by Dboxman7 from Direct swap on 67 Coupe Popped right into the U brackets with no problem. Zirc fitting threads were boogered so I had to do a little finagling to get it to thread on. Picture said it came with 4 spring clips, only came with 2 - keep the old ones, I reused 2.
Date published: 2015-03-07
Will this work with '65 289 manual 4-speed transmission?
This one won't work with that combo.
Date published: 2015-06-02
Hello, This u-joint is ok for a 289 1966 mustang 4 speed ? Regards
No, it won't fit manuals - just automatics.
Date published: 2015-03-10
Hi, I can't find the front U-joint that fits the front side of the driveshaft (the trans yoke side) for a 1968 289 C4. Will this only fit ? Because it fits a 1967 284 C4... Thanks
What is the diameter of all four caps? Since there are inner and outer snap rings, I am guessing that this is an rear U-joint. Y/N?
You Might Also Like
CJ's Low Price:$12.99