After years on the trail with rough terrain and lots of debris, your factory axle breather is most likely worn out and not working as well as it used to. This ARB Differential Breather Kit is designed to replace your stock original and get your 4WD vehicle back to peak performance.
Air Breather 170112 Features and Benefits:
- Manifold is Machined from Billet Aluminum
- Anodized Finish
- 4-Axle Breather Ports
- Compact Design and Build
- 8mm Polyethylene Tubing
- 8mm Push-In Fittings for Easy Installation
- Anodized Axle Breather Manifold
- ARB Compressor Air Filter Assembly
- 4 x 1/8" BSP Ports
- 1 x 1/4" NPT Ports
- 4 x 8mm-1/8" BSP Push-In Fittings
- 3 x 1/8" BSP Plugs
- 8m x 8mm Polyethylene Tubing
- Self-Tapping Screws (2)
- Cable Ties (25)
The differential/axle breather is very important on your four wheel drive vehicle because it vents the air pressure in drivetrain assemblies, including the differentials, transmission and transfer case. Under normal operations, these assemblies heat up and the air expands inside which increases the pressure, and when the drivetrain assembly cools down, the air inside contracts and creates a vacuum. This kit (P/N: 170112) is designed to eliminate these problems by providing a high flow, zero back pressure and zero vacuum breather system. This is achieved with the ARB compressor air filter within the central anodized billet aluminum manifold that allows all of the assemblies to be vented from one location on the drivetrain. Ideally, this location will be somewhere that is above water at all times. The kit comes with unique 8mm tubing (where most use 6mm tubes), which are essential for 4x4 applications where camber driving can cause oil to enter and block smaller breather lines.
- 2007-2018 Jeep Wrangler JK
- 2018 Jeep Wrangler JL
- 1966-1977 Ford Bronco
Order this ARB Differential Breather Kit from CJ Pony Parts today!