Door Weatherstrip Pair 1969-1970

CJ's Part Number: WSDR3
CJ's Low Price:
1508630400 40460
Earn 39 RPM Points What's this?
Door Weatherstrip Pair 1969-1970
Door Weatherstrip Pair 1969-1970 Door Weatherstrip Pair 1969-1970 Door Weatherstrip Pair 1969-1970 Door Weatherstrip Pair 1969-1970 Door Weatherstrip Pair 1969-1970

Product Description

Pair of Door Weatherstrip for all 1969-1970 Mustangs.

If you just restored the interior of your 1969-1970 Mustang, then you definitely don't want it to get damaged from water leaking in! Make sure that doesn't happen and order this Pair of Door Weatherstrip!

Over time, the weatherstripping on your doors can get damaged or cracked, or it can get ripped off and end up missing all together! This Pair of Door Weatherstrip will cover both the driver side and passenger side doors in your Mustang. It'll keep water from damaging your Mustang's interior, and it's quite easy to install! Putting this new weatherstrip on your doors will give you the peace of mind you deserve knowing your newly restored interior is well protected. This weatherstrip will fit coupes, convertibles and fastbacks.

Please Note: Weatherstrip adhesive is required for installation.

If you jump into your Mustang and notice wet floor or upholstery, it might be time to check out your Mustang's Weatherstrip to see if it is cracked or missing. For many Mustangs, CJ Pony Parts has any piece of individual weatherstrip you need, plus full weatherstrip kits, so you can completely replace every piece, keeping water outside where it belongs.

Order a Pair of Door Weatherstrip for your 1969-1970 Mustang from CJ Pony Parts today!

Similar Mustang Parts

similar Mustang parts More Mustang Parts  

Installation Instructions

Mustang Installation

Mustang Applications

This product will fit the following Mustang years:

Product Reviews

Write a review
Door Weatherstrip Pair 1969-1970 is rated 2.5 out of 5 by 2.
Rated 1 out of 5 by from junk These ended up torn in half on the shop floor for the guys to sweep up after we close. I own a car shop and try to restore every part, but rubber has to be bought. My guess is these are not "foamy" enough. They dont squish in far enough and when the top of the door is aligned, the bottom is kicked out about 1/8". It ended up twisting the doors and I will have to tweak them back into shape now. To look correct you will need to cut the rear top area due to ill fitment as stated in the other review. I will try the Scott Drake ones next and hope they are made by another vendor. According to tech support I am the only Mustang owner to have this issue, which is usually the case.
Date published: 2016-08-27
Rated 4 out of 5 by from Might be a bit long, but it worked I tried to be sure not to pull on these during install, but it still was just about 1/4' to long. Made up the difference on a corner. Also, the back portion did not snug up to the door out of the box, had to bend it a little (same on both sides). A little patience and painters tape to hold in place while the weather strip adhesive set and I am all sealed up.
Date published: 2015-06-29
  • y_2017, m_10, d_21, h_20
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.3
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_2
  • loc_en_US, sid_WSDR3, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 38.58ms

Product Questions

  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 133.69ms
  • bvseo-msg: HTTP status code of 404 was returned;

You Might Also Like