Falcon Performance Shocks Monotube Shock Absorber Kit Falcon 2.1 Series For 2" To 3-1/2" Lift 2-Door 3.6L Jeep Wrangler JL 2018-2021

Falcon Performance Shocks:

Falcon Performance Shocks Falcon 2.1 Series Monotube Shock Absorber Kit for 2018, 2019, 2020 and 2021 2-Door Jeep JL Wranglers with a 2" to 3-1/2" Lift and a 3.6L Engine.

If your 2018-2021 2-Door Jeep JL Wrangler has a 2" to 3-1/2" lift and you like to take it off-roading while still using it as your daily driver, then you’re going to need a set of shocks that can keep up! So be sure to pick1up this Falcon Performance Shocks Falcon 2.1 Series Monotube Shock Absorber Kit that’s now available at CJ Pony Parts! 

Features & Benefits:
- 6061-T6 Aluminum Alloy Shock Body Resists Wear and Protects Internal Components While Providing Superior Heat Dissipation
- Smooth Honed Internal Shock Body Surface for Long-Term Performance
- 2-1/4" Shock Body Provides Optimal Performance
- Delivers Increased Stability and Improved Ride Quality and Comfort for Daily Driven Jeeps in Compact, Affordable Package
- Optimized for On- and Off-Road Driving and for Clearance During Full Suspension Travel
- Corner-Specific with Race-Inspired Performance, Handling and Stability for Off-Road Rigs
- Volume Optimized Damping (VOD): Digressive Linear Valve Produces Quicker Ramp-Up for Increased Damping Volume to Improve Jeep Feedback, Dynamic Roll Control and Control During Low-Speed Driving
- VOD Improves Shock’s Ability to Reduce Bottoming Out at Full Compression During Faster Speeds or Over Uneven Terrain
- Improved Low-Speed Damping
- Rear Roost Guards Prevent Shock Shaft Damage from Rocks Kicked Up by Tires
- Built from the Ground Up with Focus on Fitment and Function to Deliver Best Damping Characteristics Possible
- 3/4" Induction-Hardened Chrome-Plated Shaft Resists Rock Damage and Corrosion and Prevents Shaft Buckling
- Maximum Shaft Diameter Allows for More Precise Tuning
- Hard Anodized Billet Piston
- 1-Piece Teflon Bronze Piston Wear Band with O-Ring
- Inline OGS Oil/Gas Separator to Prevent Cavitation
- Red Line Full Synthetic Shock Oil with High Viscosity Index of 519 for Consistent Performance Across All Temperatures and Reduced Shock Fade
- Synthetic Formula Also Contains Special Anti-Wear and Lubricity Agents for Excellent Thermal Stability
- 1000-Hour Salt Spray Corrosion-Resistance Test Done on All Hardware
- Serviceable and Rebuildable (Factory Serviced)
- Fits 2018-2021 2-Door Jeep JL Wranglers with 2" to 3-1/2" Lift
- Built In-House at Falcon Shocks Division
- Installation Time: 1-1/2 Hours
- Made in the USA 

This Falcon Performance Shocks (10-01-21-400-200) Falcon 2.1 Series Monotube Shock Absorber Kit comes with 4 new shock absorbers for your JL! Each one features an aluminum alloy shock body that resists wear and protects the internal components while still providing superior heat dissipation. They’re optimized for both on- and off-road driving and for clearance during full suspension travel. You’ll notice an increase in stability and improved ride quality and comfort after you install them. Plus, you’ll see an improvement in low-speed damping! And the included rear roost guards prevent shock shaft damage from any rocks you kick up. Installation is easy and should take you about an hour and a half total. 

- Four (4) Series 2.1 Monotube Shock Absorbers
- Pair of Rear Roost Guards
- All Necessary Hardware 

*Must extend bump stop strike pads a minimum of 2". 

California Residents: Proposition 65 Warning

Installation Difficulty


Novice skill is required for this installation.

Vehicle Fitment

This product will fit the following Wrangler years:

Only registered users can ask/answer questions. Please sign in or create an account.
Write Your Own Review
Only registered users can write reviews. Please sign in or create an account.