Ford Performance Power Pack Upgrade Stage 1 GT 2015-2017

Ford Performance:
M-9603-M8
Ford Performance Power Pack Upgrade Stage 1 GT 2015-2017 is rated 5.0 out of 5 by 1.
  • y_2020, m_1, d_22, h_19
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.4
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_1
  • loc_en_US, sid_M9603M8, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.2.1
  • CLOUD, getAggregateRating, 129.53ms
  • REVIEWS, PRODUCT

Highlights

  • Includes Drop In K&N Filter
  • 13HP & 16 Lb-Ft Over Stock
  • 50 State Legal
  • Requires 91 Octane Or Higher
MSRP $599.00
$404.99
You save 32%

Ford Performance Stage 1 Power Pack Upgrade for all U.S. and Canadian 2015, 2016 and 2017 GT Mustangs.

The wait is over! We are proud to finally offer you the opportunity at owning the new Stage 1 Power Pack Upgrade (P/N: M-9603-M8) for your U.S. or Canadian 2015-2017 Mustang GT from Ford Performance!

This Ford Performance Stage 1 Power Pack Upgrade Package will give your GT S550 up to 13 more peak horsepower and up to 40 lb-ft of torque at only 1500rpm. You will notice a huge improvement in your Mustang's off-the-line responsiveness with improved and enhanced throttle response and a performance feel. Automatic transmission calibrations feature an optimized performance shift schedule while manual transmission calibrations feature an exclusive “No-Lift” shift strategy. The proprietary software will also allow rear gear ratio changes up to 4.09:1. Best of all, this incredibly versatile performance upgrade package is legal in all 50 states and features a CARB EO#.

Included in Kit:
- K&N High Flow Air Filter Replacement
- Ford Performance ProCal Tool

Features and Benefits:
- Fits ALL 2015-2017 U.S. and Canadian Spec GT Mustangs
- Calibrations Available for both Manual and Automatic Transmissions
- Automatic Transmission Calibrations Feature Optimized Performance Shift Schedule
- Manual Transmission Calibrations Feature Exclusive No-Lift Shift Strategy
-
Improved and Enhanced Throttle Response with a Performance Feel
- Uses Proprietary Software Backed by Extensive Engineering
- Software Will Allow for Gear Ratio Changes up to 4.09:1
- All Calibrations are 50 State Legal with a CARB EO#
- Significant Gains of 40lbs/ft at Only 1500rpm
- 13hp and 16lbs/ft Peak Gains Over Stock

Please Note: Requires a laptop (NOT Included) and internet access for calibration installation.

*Powertrain calibration is developed and supported for U.S. and Canadian vehicles ONLY.
*Premium fuel, 91 octane or higher, is required.

Manufacturer Part Number: M-9603-M8

If you're looking for quality parts for your 2015-2017 Mustang, you should start by looking at the great selection of parts that CJ Pony Parts offers from Ford Performance (formerly Ford Racing). By buying your Ford Performance parts from CJ Pony Parts, you know you're getting your Mustang parts from a reliable, reputable dealer, since CJ Pony Parts is a Top 10 Ford Performance Dealer and has been for the last 10 years. When you buy your Ford Performance Mustang parts from CJ Pony Parts, you know you will have a winning combination.

Order this Ford Performance Stage 1 Power Pack Upgrade for your U.S. or Canadian 2015, 2016 or 2017 Mustang GT from CJ Pony Parts today!

This item is 50-state legal (CARB E.O. Number D-598-19)

Installation Difficulty

Easy
Easy

Novice skill is required for this installation.

Installation Videos

Vehicle Fitment

This product will fit the following Mustang years:

Rated 5 out of 5 by from Stage 1 install on a 2016 base GT Automatic This was a really simple install. The air filter took a whole 3 minutes to install. Downloaded the software (on a windows 10 laptop)with the included license key. Read the directions on the downloaded PDF file. I HIGHLY recommend thoroughly reading the directions before plugging into the OBD port (click on the question mark in the application and it loads the PDF for reading). Start to finish was under 30 minutes. I'm stuck with 91 octane here in Arizona. People back east with 93 octane fuel will probably see increased results. The car shifts have firmed up a bit. The torque is very noticeable off the line to about 2500. Took it out on the freeway and floored it at 65. I have a stock exhaust with the resonator removed with an H pipe installed (bought here at this site -highly recommended). I've never heard the car roar so loudly or accelerate so strongly before. I was into triple digits very quickly. I also noticed that under WOT the car shifts at 6500 RPM where I believe before it shifted at 6K. I did this with the transmission in "D" not "S". So for not a lot of money and a straightforward easy install -you can't go wrong.
Date published: 2016-08-28
  • y_2020, m_1, d_22, h_19
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.4
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_1
  • loc_en_US, sid_M9603M8, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.2.1
  • CLOUD, getReviews, 4.98ms
  • REVIEWS, PRODUCT

I'm looking to flash the car back to stock but have lost the stock tune file, do you have one? Could you send a copy to me?

Asked by: Reed
You will have to go back to ford for a stock tune.
Answered by: rk cjpp
Date published: 2019-12-16

I have stock air box but fitted with AFE dry filter...can tune be done with my set up? not a fan of oiled filters. 2017 GT PP

Asked by: dman
checked with Ford Performance...no problem
Answered by: dman
Date published: 2019-03-16

can this be installed with stock air filter box and Airaid intake tube?

Asked by: dman
Because of the tune you would have to use the stock air tube.
Answered by: rk cjpp
Date published: 2019-03-14

Do You have the rhd version of the pp1? Thanks

Asked by: Pretiger
Sorry we do not.
Answered by: rk cjpp
Date published: 2018-08-15

Can this tune be used for Australia models? I understand that is says US and Canada only though is there a difference in the software that would prevent it from working or is it because Aus is RHD If it is to do with the fuel type I only use Ron 98

Asked by: GC20
This is not compatible for non U.S. models.
Answered by: rk cjpp
Date published: 2017-10-24

Can you use an Airaid closed box CAI with the Ford Power Pack Stage 1 on a 2017 Mustang GT Automatic, Will it set off air metering codes and warning lights, I understand anything form cat back is fine on exhaust , what about intake side?

Asked by: Hildalgo123
You can only use the parts included in the kit.
Answered by: rk cjpp
Date published: 2017-10-03

I have the roush cold air intake. Is this tune compatible? It seems almost identical to the roush tune.

Asked by: Nick competition orange
As long as you left the insert in the Roush Intake, this would work fine.
Answered by: CJPP Dave
Date published: 2017-03-21

My 2015 GT has a Airaid cold air induction. Would there be a problem using the Ford Power Pack 1 with the Airaid seeing as how that is not stock and Ford seems to have set up their Power Pack to work with the factory intake. Thanks, BJ

Asked by: LT210
This is not intended to be used with any other intake other than the stock one with the supplied drop in filter.
Answered by: CJPP Dave
Date published: 2018-09-17
  • y_2020, m_1, d_22, h_19CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.4
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_13
  • loc_en_US, sid_M9603M8, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_cjponyparts
  • bvseo_sdk, p_sdk, 3.2.1
  • CLOUD, getContent, 132.95ms
  • QUESTIONS, PRODUCT