Mustang Power Steering Return Hose (1965-1966) Installation Instructions
The Power Steering Return Hose will fit all 1965-1966 Mustangs.
After many years, the power steering on your classic 1965-1966 Mustang may be causing you problems. However, it might not be a big issue, since all of the hoses may have more than 50 years of use, which could lead to rot, corrosion and failure. Replace the Power Steering Return Hose with this new version, and get your power steering back in gear again!
Tools Required:
- Wheel Chocks, Jack & Jack Stand
- Flat Head Screw Driver
- Bucket/Rags
- 11/16-inch Tubing Wrench
- 1/2-inch Socket, Extension & Ratchet
- Utility Knife
Install Difficulty:
- Easy Project
1. To begin the installation of your new Mustang power steering return hose, safely chock the vehicle's rear wheels and place jack stands securely under vehicle, after jacking the front end up.
2. Place a container under the Mustang power steering control valve to catch any lost fluid. Have rags and or cat litter handy in case of a spill.
3. To have access to the return hose fitting on the control valve, turn the Mustang steering wheel all the way to the right.
4. Loosen the return line fitting at the control valve with an 11/16-inch tubing wrench until it is out of the control valve.
5. Loosen the bolt holding the insulator bracket to the frame. Pull the Mustang steering hose out of the insulator.
6. Finish the removal process by removing the return hose clamp on the back of the pump and slide the hose off the metal tube. Be careful not to damage or crack the tube in the process.
7. Installation of the new hose can now be completed by following the removal instructions in reverse. Make sure that all connections are clean so you do not risk contaminating the new fluid or components. Always start threaded fittings by hand. Never use a wrench to start a threaded fitting as you can cross thread or damage the threads. Also be sure that the new hose and tubing are correctly aligned so it does not rub on anything that would cause damage or failure.
8. Lower the vehicle from the jack stands and fill the Mustang power steering pump with fluid to the correct level.
9. Start the vehicle and slowly turn the steering wheel all the way both left and right. You might hear some whining noise from the pump for a few seconds as the air bleeds out of the system. This noise will stop. Recheck the fluid level and top off if needed.
10. Check the Mustang steering hose you just installed for any leaks.
11. The installation of you new Mustang power steering return hose is finished! Enjoy the test drive.
