Mustang Scott Drake Show Quality Taillight Lens (1965-1966) Installation Instructions
This Show Quality Taillight Lens from Scott Drake will fit all 1965-1966 Mustangs.
After nearly 50 years, you can bet the taillight lenses on all but the best maintained Mustangs are going to be cracked, faded or otherwise looking poor. That's why CJ Pony Parts and Scott Drake offer this show quality replacement, which gives you a show quality taillight lens that's exactly like the original, down to the finest details, making it perfect for any restoration or repair.
Tools Required:
- Phillips Head Screw Driver
- Flat Head Head Screw Driver
Install Difficulty:
- Easy Project
1. To start the installation of your new Mustang Scott Drake C5ZZ-13450-AR taillight lens, remove four Phillips head screws from the taillight bezel.
2. Carefully remove the Mustang taillight bezel from the car. The taillight lens may come out with the bezel or be stuck to the seal on taillight housing. If it gets stuck, gently pry it loose. Be careful to not scratch or chip the paint.
3. Remove any remnants of the seal around the taillight lens. Clean out the housing of the Mustang taillights and the bezel of any debris or rust. Check the brake light bulb while you have access to it and change the bulb if necessary.
4. Place the new Scott Drake lens inside the bezel along with the new gasket.
5. Place the assembly back on the car. Be careful to not scratch or chip the car's paint. Reinstall the four Phillips head screws securely. Test the light to ensure that everything is working. You are now finished installing your new Mustang Scott Drake taillight lens.
