JLT Performance Oil Separator Kit 3.0 Black Anodized Passenger Side Mustang GT 2011-2017/ Boss 302 2012-2013/ GT350 2016
- Made of Billet Aluminum
- Multi-Stage Filtration
- Extra Oil Capacity
- O-Ring Tight Seal
JLT Performance Black Anodized Passenger Side 3.0 Oil Separator Kit for 2011, 2012, 2013, 2014, 2015, 2016 and 2017 GT Mustangs and 2012-2013 Boss 302 Mustangs and 2016 GT350 Mustangs.
California Residents: Proposition 65 Warning
Note: This item is not CARB (California Air Resource Board) exempt and is not legal for sale or use in the state of California.
Novice skill is required for this installation.
The 3.0 holds 3 full ounces of fluid, which is quite a bit when you're talking about oil separation. This is a 2-stage oil separator, starting with a fine-mesh stainless steel screen and going through a honeycomb filter, finally ending in the bottom of the storage of the separator itself. They're available in the black anodized finish shown here, or also a clear anodized.
The JLT oil separator features billeted aluminum construction and is very easy to empty. Grab the bottom here, dump out any oil, there you can see the honeycomb filter. Once it's empty, just thread it right back on. We have our 2015 engine on a stand, but the installation is the same on all models and couldn't be easier. We pull back on these little gray clips, pop off the factory home and remove it, grab your separator. It uses factory fittings, so simply slide it in place, lock it on. Same thing down there. That's all there is to it.