MagnaFlow Axle-Back Exhaust System MF Series Polished With Dual 4" Tips Jeep Wrangler JK 2007-2018
- 2.5" Mandrel Bent Tubing
- Dual 4" Polished Tips
- 409 Stainless Construction
- Easy Installation
MagnaFlow Polished MF Series Axle-Back Exhaust System with Dual 4" Tips for 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 and 2018 Jeep JK Wranglers.
This Polished MF Series Axle-Back Exhaust System with Dual 4" Tips from MagnaFlow will increase the power and performance of your 2007-2018 Jeep Wrangler JK. It will also provide your JK with a smooth, deep exhaust tone. Plus, it looks great too!
Features and Benefits of the MagnaFlow Polished MF Series Axle-Back Exhaust System with Dual 4" Tips (15178):
- Constructed out of durable 409 stainless steel
- Increases horsepower and torque
- Mandrel-bent tubing
- 2-1/2" diameter pipe
- Dual split rear exit
- Comes with stainless steel band clamp
- Manufactured in the USA
- Fits ALL 2007-2018 2-Door and 4-Door JK Wranglers
This split exit performance exhaust system features a straight-through flow design for added horsepower and torque gains. It has an engineered balance of interior and exterior noise levels. MagnaFlow crafts this premium exhaust kit in the USA from high-grade stainless steel!
CJ Pony Parts offers a wide variety of MagnaFlow products for our customers. If you're looking for one of the top performing and best sounding exhausts on the market, you'll want to check out our selection of MagnaFlow parts.
Order MagnaFlow's 15178 Polished MF Series Axle-Back Exhaust System with Dual 4" Tips for your 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 or 2018 Jeep JK Wrangler from CJ Pony Parts today!
California Residents: Proposition 65 Warning
Novice skill is required for this installation.
This axle-back exhaust is going to be super easy to install because there's only one 15 millimeter nut holding it on. Then you just have to remove the muffler from the two rubber hangers. Remove the 15 millimeter nut on the exhaust clamp ... Now we're going to remove this bracket from the rubber hanger on the Jeep ... All right, now we can move to the other hanger. Once both hangers are disconnected, grab onto the muffler and twist it to break it lose from the pipe, then you can pull it off.
With the factory exhaust out of the way, the first thing we're going to do is place the provided clamp over the over axle pipe. Place the passenger side hanger over the bracket on the muffler, then place the muffler into the driver side hanger then the over axle pipe ... Slide the clamp over the inlet pipe. Then tighten it with a 15 millimeter socket. Your installations finished.
All right, let's see how it sounds ... Our MagnaFlow axle-back exhaust is installed. Installation was super easy. Gave our Jeep a nice tone, but it's not too loud. Installation will take you about 30 to 45 minutes, and before you know it you'll be heading off-road.
This product will fit the following Wrangler years: