Mustang 4.6L Transmission Mount (1996-1998) Installation Instructions
This transmission mount fits all 1996-1998 4.6L Mustangs.
If the transmission mount in your 1996-1998 4.6 Liter Mustang is broken and needs replacing, this transmission mount is a stock replacement, exactly like the original, factory transmission mount.
Tools Required:
- Ratchets & Sockets
- Wrenches
- Jack & Jack Stands
Install Difficulty:
- Moderate Project
1. To begin installing your new Mustang 4.6L Transmission Mount, raise your car on jack stands to give yourself enough clearance to work under the transmission.

2. Locate your transmission mount, which is towards the rear of your Mustang transmission.

3. Remove the two bolts that hold the transmission mount to the transmission. Then, remove the two nuts that hold the transmission mount to the Mustang transmission crossmember. Once all of the bolts are removed, raise your transmission slightly with a jack and slide the mount out.

4. Install your new transmission mount in the same way your old one was removed. Install the mount and bolt it to the transmission. Then, lower your transmission back onto the crossmember. Make sure the holes in the mount line up correctly. Then, bolt the new transmission mount to the crossmember. Make sure everything is snug, then take the car for a drive to ensure the transmission is secure. At this point, you've completed installing your new Mustang stock replacement transmission mount.
