Mustang Brushed Aluminum Dash Trim Kit (1967) Installation Instructions
1967 Mustang Brushed Aluminum Dash Trim Kit
This Brushed Aluminum Dash Trim Kit will fits 1967 Mustangs.
Upgrade the appearance of the dash trim with this Brushed Aluminum Dash Trim Kit for 1967 Mustangs without air conditioning. The three piece kit installs easily, with only hand tools, and upgrades the appearance of your Mustang's dash trim immensely!
This Brushed Aluminum Dash Trim Kit will fits 1967 Mustangs.
Upgrade the appearance of the dash trim with this Brushed Aluminum Dash Trim Kit for 1967 Mustangs without air conditioning. The three piece kit installs easily, with only hand tools, and upgrades the appearance of your Mustang's dash trim immensely!
Tools Required:
- Screw Drivers
- Pliers
- Ratchet/Sockets
Install Difficulty:
- Easy Project
1. To start the installation of your new Mustang Brushed Aluminum Dash Trim Kit, you will need to remove the existing instrument cluster and dash trim.


2. Remove the original instrument cluster assembly. There are three screws across the top and two at the bottom of the cluster that need removed to remove the panel. Also, remove the two electrical plugs from the under dash wiring harness and the speedometer cable.

3. The horizontal pieces of the old dash trim are held in place by multiple thin walled metallic fasteners. The Mustang passenger door side vertical trim piece is held in place by two screws and nuts.


4. Inspect the new Mustang dash trim. I used brushed aluminum version.

5. Set the Mustang brushed aluminum center panel in place.

6. Install the instrument cluster and the Mustang upper right dash trim panel from the kit.

7. Use a new Mustang dash trim mounting kit, or the old hardware, to attach all of your new dash trim.

8. The vertical Mustang dash trim for the passenger's side is kept in place with the two screws and nuts that get installed on the bottom edge.


9. Enjoy your new Mustang Brushed Aluminum Dash Trim Kit.