Old Air Products A/C/Heat And Defrost Kit Hurricane With Electronic Control Chevrolet C10 1964-1966

Old Air Products:


  • For 1964-1966 Chevy C10s
  • Mounts to firewall
  • Replaces factory heater box
  • Electronic style control panel

Old Air Products Hurricane A/C, Heat and Defrost Kit with an Electronic Slide Control for 1964, 1965 and 1966 Chevrolet C10s.

Upgrade the A/C, heater and defrost system in your classic 1964-1966 Chevrolet C10 with this Old Air Products CAP-6610 Hurricane A/C, Heat and Defrost Kit with an Electronic Slide Control. The Hurricane Series Heat Cool and Defrost Unit mounts to the firewall in your pick-up using the existing holes in firewall. Custom mounting plates position the unit so A/C and Heater fittings pass through the original square blower motor inlet hole and seal with a custom rubber grommet. Louvers mount neatly along the bottom edge of the dash. The Control package includes a Replica Electronic Control that fits into the original factory dash opening maintaining your interior style. Electronic servo motors operate the defrost and heater valve functions. This unit also retains a majority of the glove box while leaving valuable space inside the dash for radio, CD player and gauges.

Features and Benefits:
- For 1964-1966 Chevy C10s
- Mounts to firewall
- Replaces factory heater box
- Two lever style heater control panel

Kit Includes:
- Hurricane Heat Cool & Defrost unit
- Mounting kit w/ Bracket/Plates/Hardware
- Electronic Control package
- Wire harness
- Electronic bypass heater valve
- Underdash louvers
- Duct hose
- Condenser assembly with drier and tubes
- A/C hose kit
- Compressor
- Compressor mounting bracket
- Pressure safety switch

The leader in air conditioning systems and replacement parts for classic, custom and antique vehicles, Old Air Products was established in 1989 with the concept of manufacturing an A/C, Heat and Defrost system that would fit any vehicle. Their focus on customer needs sets them apart from the competition in more ways than one.

*How to measure a Chevy water pump to determine which bracket is needed to mount the compressor: Measure from the pulley mounting flange to the front of the engine where the water pump is bolted to the block. (Short water pump: 5-5/8”. Long water pump: 7”)

Please Note: 
- Typically a short water pump was used on Chevrolet Small block V8 engines in trucks up to 1972.
- This part is non-returnable.

California Residents: Proposition 65 Warning

Vehicle Fitment

This product will fit the following C10 years:

Only registered users can ask/answer questions. Please sign in or create an account.
Write Your Own Review
Only registered users can write reviews. Please sign in or create an account.