Oracle Lighting Headlight LED Dual Projector 7" Black With ColorSHIFT Halo Ring Pair Jeep Wrangler TJ 1997-2006/ JK 2007-2018
Pair of Oracle Lighting Black 7" Dual Projector LED Headlights with ColorSHIFT Halo Rings for all 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005 and 2006 Jeep TJ Wranglers, and for all 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 and 2018 Jeep JK Wranglers.
California Residents: Proposition 65 Warning
First part of the installation is removing the grill by removing the six clips that hold it in place. Remove the four T-15 screws holding in the headlight. Once you get the last screw out, unplug the connector from the headlight and remove the headlight. Grab the Oracle adapter harness and install that first. Then, plug in the headlight harness. Fish the Halo wiring up into the engine compartment, then plug the headlight in. Snap the headlight into place and install the headlight ring. Once you have both halos in, reinstall the grill. Plug in the Oracle module into the LED halo and then hide the wiring. Split apart these wires just to give you a little bit more room to work with. That'll make it easier to wire up.
Grab your Oracle LED controller and plug in the wires from the halos into it. The red wire will go in the R slot, green wire in the G slot, B wire in the B slot, but then the black wire goes in this DC+. Over here is the positive and ground wire. Now we can hook up the power and ground wire. You can now hook up the power and ground wire. You can wire this up any way would like, but we're going to wire ours into our Trail Rocker system. With all the wires hooked up, we can now hook up the remote sensor to it. If you want to use a remote, this kit does come with a remote and a receiver, so we're going to mount the receiver for the remote right here on the dash and run the wire up the kick panel, through the grommet in the firewall, and then connect it to the controller. Peel off the adhesive backing, stick it onto the dash, and then hold it there for about 30 seconds to make sure it sticks. Pull the wire up through the grommet in the firewall, then plug it into the controller.
Clean up the wiring and find a good place to mount this, and then your installation is finished. Our Oracle LED halo headlights are installed. They give our Jeep a nice modern touch. What's important to note that these are for off-road use only. Installation will you about an hour, and before you know it you'll be heading off road.