PerTronix Distributor HEI Flame-Thrower With HEI III Module 289/302
PerTronix Flame-Thrower HEI Distributor with HEI III Module for 289 and 302 Engines.
If you are looking to upgrade the ignition system of your 289 or 302 engine, then you should have a look at this PerTronix Flame-Thrower HEI Distributor with HEI III Module from CJ Pony Parts! Designed for 289 and 302 small block engines, this Flame-Thrower HEI Distributor comes in a lightweight aluminum alloy housing with a high dielectric strength cap, brass terminals, and low resistance coil brush. Integrated into the HEI III module is a built-in rev limiter with LED feedback that allows precise RPM setting. And at higher RPMs, the distributor will adjust the spark timing to compensate for the inherent electronic delay.
The Flame-Thrower HEI Distributor features a specially designed module and coil combination that allows the distributor to operate beyond 7500 RPM without misfiring! It will also eliminate erratic timing through the use of precision machined chromoly advance weights and center plate. The distributor provides 67% more energy and a 45% faster spark breakdown when compared to stock HEI distributors. You can also fine tune the advance curve with the additional advance springs! To maintain peak energy throughout the RPM range for improved performance, the distributor utilizes adaptive dwell control, which will also reduce the chance of having misfires.
PerTronix Flame-Thrower HEI Distributor Features and Benefits:
- Lightweight aluminum alloy housing
- High dielectric strength cap
- Brass terminals
- Low resistance coil brush
- Integrated digital REV limiter with LED feedback for precise RPM setting
- Adjusts spark timing at higher RPMs to compensate for the inherent electronic delay
- Senses startup and increases energy for quicker, easier starting
- Balanced rotor with nylon screws prevent arcing and reduce vibration at high RPMs
- Eliminates erratic timing through precision machined chromoly advance weights and center plate
- Additional advance springs allow fine-tuning of the advance curve
- Provides 67% more energy with a 45% faster spark breakdown over stock HEI distributors
- Centerless ground shaft reduces friction and provides concentric operation
- Steel distributor gear that is ground to exact tolerances for tighter mesh with camshaft
*A smaller diameter air cleaner is recommended for use with this distributor.
If you have an older Ford, you've probably replaced the points and condenser in the distributor a few times during tune-ups. However, what if there were modern parts for classic Fords that eliminate the need for distributor maintenance? With the products from PerTronix, there is, allowing you to have a much more reliable and maintenance free ignition. These products, along with the other high quality upgrade parts from PerTronix can help give your ignition system a complete make-over!
Order this PerTronix Flame-Thrower HEI Distributor with HEI III Module for your 289 or 302 Engine from CJ Pony Parts today!
This product will fit the following Bronco years:
This product will fit the following F-100 years:
This product will fit the following Mustang years: